I believe it is horizontal by vertical. (example: 12x24)
Chat with our AI personalities
There is not an agreed standard size.
There are often multiple 'correct' dimensions for these problems. The most straight forward way to solve it is to list all the factors that, when multiplied, equal the area. Then from this list, cross out the factors that DON'T equal your perimeter. The remaining factors are your possible dimensions.
Standard brick dimensions are 215x102.5x65mm.
There is no standard way. Futhermore, by themselves, a list of side lengths provides very limited information. Apart from a triangle, the area of a polygon cannot be determined from the length of its sides.For a polygon, start with the length of an identified side, and go round in one direction - stating whether you are going clockwise or anticlockwise.There is no standard way. Futhermore, by themselves, a list of side lengths provides very limited information. Apart from a triangle, the area of a polygon cannot be determined from the length of its sides.For a polygon, start with the length of an identified side, and go round in one direction - stating whether you are going clockwise or anticlockwise.There is no standard way. Futhermore, by themselves, a list of side lengths provides very limited information. Apart from a triangle, the area of a polygon cannot be determined from the length of its sides.For a polygon, start with the length of an identified side, and go round in one direction - stating whether you are going clockwise or anticlockwise.There is no standard way. Futhermore, by themselves, a list of side lengths provides very limited information. Apart from a triangle, the area of a polygon cannot be determined from the length of its sides.For a polygon, start with the length of an identified side, and go round in one direction - stating whether you are going clockwise or anticlockwise.
A standard 44-gallon drum typically has dimensions of approximately 23 inches in diameter and 34 inches in height. These dimensions can vary slightly depending on the manufacturer and the specific design of the drum.