0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
When chip thickness ratio greater than 1?
When Rack angle is zero... Chip thickness ration is going to be greater.
How many square feet at 1 Mil thickness will 1 gallon of water cover?
21
In discrete geometry does a line have thickness?
No. It is 1-dimensional : it has only a length.
What is the area you can cover with 1m3 if the layer is 100mm thick?
Volume = (length) x (width) x (thickness) = (area) x (thickness).Thickness = 100 mm = 0.1 mVolume = 1 m31 m3 = (area) x (0.1m)Area = 1 m3/0.1 m = 10 m2
What is the height of 1 penny?
The height of a penny is the thickness: 1.55 mm (millimeters)
Photo paper thickness?
The Paper Thickness is 1milimeter 1/1000
What is the standard thickness of a counter top poured out of concrete?
Most countertops of this nature are 1-1/4" to 1-1/2" in thickness.
What is the average thickness of beverage cans thickness for 1 gram metal for a 35 cm piece?
The thickness of a typical aluminum beverage can is around 0.09 mm. To calculate the thickness for 1 gram of metal in a 35 cm piece, you would first convert 1 gram to the equivalent thickness based on the density of the metal (aluminum has a density of about 2.7 g/cm³), then divide the total length by this thickness.
What does 1 4 inch thickness look like.?
14-little longer than a standard ruler. 1/4-about thickness of a pen
What is thickness of 2 x 4?
1-1/2
What is a millimeter closest to in thickness?
A millimeter is closest in thickness to the thickness of a credit card or the edge of a dime.
How many square foot of tin are there in 1 cubic yard?
There are 6,912 square feet of tin in 1 cubic yard, assuming the tin is rolled out to a thickness of 1/1000 inch.
What has the length of 1 millimeter?
thickness of a nail..
Standard thickness of ceramic tile?
Ceramic tiles range from 1/4 to 3/4 inch in thickness.
What thickness of fiberglass is generally used in a baptistry?
A quick scan shows baptistries from 1/2" to 2" thickness.
What is ratio of gauge to mil in plastic thickness?
The ratio of gauge to mil in plastic thickness is 1 gauge = 0.1 mil. This means that for every 1 gauge increase, the thickness increases by 0.1 mils.
When chip thickness ratio greater than 1?
When Rack angle is zero... Chip thickness ration is going to be greater.
