0
What else can I help you with?
What is size of a walnut?
From one inch to 2 inch...depends on the quality
Does one inch equal to the size of a finger?
It depends what size your finger is.
What is Font size that equals one inch mean?
Font size is usually measured in points; 1 inch is approximately 72 points.
Is a inch the same size as a centimeter?
No. A inch is as long as 2.54 centimeters end-to-end.
What size hole for a half inch tap?
For a half-inch tap (specifically a 1/2"-13 tap, which is common for coarse threads), the recommended drill bit size is typically 27/64 inches, or approximately 10.7 mm. This size provides the appropriate clearance for the tap to create threads in the material. Always consult a tap drill chart for specific applications, as fine thread taps may require different sizes.
What is the stock subwoofer size in a Oldsmobile aurora?
measure the diameter of the hole for the speaker/subwoofer and the distance to each bolt hole to asure you get the right subwoofer to fit properly.
What size is the subwoofer in a 2009 Dodge Ram?
10 Inch
What size is the sub woofer in a 2003 ford expedition?
The size of subwoofer is 8 inch
What size subwoofer in ford edge?
It's a 9 inch woofer.
What is the actual hole size for 1 inch conduit?
Actual hole size for 1 inch conduit is 1.362"
What size is the subwoofer in a 2001 Chevy surburban?
if it is a stock sub woofer it should be an 8 inch
What is size of rear subwoofer for 2001 Toyota Avalon?
JBL 8 inch. 3.7 ohm
What size is the subwoofer in the 1998 Linocln town car?
8 inch or 10 inch is nice. give you one nice guide
What size subwoffer will fit in a 9 inch hole?
8 inch sub
What is the recommended drill bit size for a 15/64 hole?
The recommended drill bit size for a 15/64 inch hole is a 15/64 inch drill bit.
What is the recommended pocket hole screw size for 3/4 plywood?
The recommended pocket hole screw size for 3/4 inch plywood is 1 1/4 inch.
What is the recommended size of the drill bit to use for a 7/16 hole?
The recommended size of the drill bit for a 7/16 inch hole is a 7/16 inch drill bit.
