0
Add your answer:
Earn +20 pts
The horizontal axis of production function typically measures?
The number of units manufactured.
Can the slope of a line be a fraction?
Of course. If the line rises 18 units for every 27 horizontal units,then its slope is 2/3 .
What is the graph for y equals 5?
It is a horizontal line 5 units above the x-axis.
What part of a fraction tells how many units the fraction contains?
The denominator (the figure below the horizontal line)
How do you graph -2y equals 6?
-2y = 6 so y = -3 This is a horizontal line at a height of -3 units ie 3 units below the x-axis.
How is frequency measured on an oscilloscope?
Frequency is, in general, measured on an oscilloscope by looking at the display and making a small calculation. By determining the number of "units" a cycle of an observed wave takes up on the screen and incorporating the sweep rate as set by the operator, you can find the frequency. To do this, look at the signal. Increase the vertical sensitivity to make the wave "take up most of the screen" without chopping any of its amplitude off. Center the signal vertically in the display. Then adjust the sweep rate to get more than one but less than two complete cycles of the wave on the display. Now count the number of "units" on the graticule from the "start" to the "end" of one complete cycle. Lastly, take the horizontal sweep rate from the dial and apply that to the number of units you counted on the graticule. The sweep rate will be in time per graticule unit. Multiply this by the number of units that you counted for a cycle. You'll calculate the total time per cycle from this information. What you will actually get is the period of the wave. It will be the time it takes for one complete cycle of the wave. The period of the wave is the time per cycle of the wave. With the period, you can simply invert it to find the frequency in cycles per second (Hertz). Seconds per cycle inverted is cycles per second.
Where are all points whose y-coordinates are -3?
On a horizontal straight line, three units below the x axis. On a horizontal straight line, three units below the x axis. On a horizontal straight line, three units below the x axis. On a horizontal straight line, three units below the x axis.
What are the coordinates for (2-1) vertical shift 2 units up and horizontal shift 6 units down?
You cannot have a horizontal shift in the down direction: a horizontal shift must be left or right!
What does give the vertical and horizontal translation in units?
Not sure
Why cooled air is thrown from top in air conditioner?
Not always true. There are upflow units, downflow units and horizontal side discharge units.
What are the five main component of oscilloscope?
1.3.3 Automatic sweep mode; 1.3.4 Recurrent sweeps; 1.3.5 Single sweeps ... The basic oscilloscope, as shown in the illustration, is typically divided into translucent windows in the panel to illuminate different parts of the sensitivity scale.
The horizontal axis of production function typically measures?
The number of units manufactured.
Can the slope of a line be a fraction?
Of course. If the line rises 18 units for every 27 horizontal units,then its slope is 2/3 .
What is the graph for y equals 5?
It is a horizontal line 5 units above the x-axis.
What is the highest resolution for TV today?
The highest resolution is used by HDTV, 16:9, which means 16 horizontal units for every 9 vertical units.
What units of time are MPU cycles rated?
j
Power supply units are rated in?
Power supply units are rated based on their output and efficiency. When more equipment is connected, a higher output power supply is needed.
