The volume of a cylinder is:
V1 = pi r2 h
V2 = pi (2r)2 2h = pi 4r2 2h = 8pi r2 h
V1/V2 = (pi r2 h)/(8 pi r2 h)
V1/V2 = 1/8
Thus, V2 is 8 times bigger than V1.
Can of beans/vegetables etc.
are you talking about the meniscus? hope thats what you were looking for!
To calculate the number of barrels of cement slurry needed to fill a 15-inch diameter well that is 1800 feet deep, first, we find the volume of the well. The volume (V) can be calculated using the formula for the volume of a cylinder: V = πr²h, where r is the radius (7.5 inches or 0.625 feet) and h is the height (1800 feet). This results in a volume of approximately 7,068 cubic feet. Since a standard barrel of cement slurry is about 5.61 cubic feet, you would need around 1,260 barrels to fill the well.
you cant compare the two because ml is used to measure volume and cm2 is used to measure area. Thats just what i think. =D
Recoverable reserves= Volume of hydrocarbon * recovery factor Recoverable reserves= [7758* Vf*P*((1-Sw)/FvF)] * R.F Vf:Volume of producing formation(acre-feet) P: Porosity Sw: Water Saturation FvF: Formation Volume Factor R.F: Recovery Factor(Percentage of oil in place thats recoverable)
Diameter 6.6 cm ( radius 3.3 cm) , length 10 cm .If thats internal dimensions,then volume = pi * r2 * length = 3.1416 * 10.89 * 10 = 342.12 cu. cm.
i dont know thats why im asking the internet
Can of beans/vegetables etc.
the units of density are mass/volume so anything that gives you those variables. A scale and graduated cylinder be used if you fill the cylinder with water and the monitor the displacement of the water. 1ml of water is equal to 1 cubic cm (thats volume)
thats easy its your mom
Thats an inference
are you talking about the meniscus? hope thats what you were looking for!
i dont know thats why im asking the internet
With the middle cylinder, its in between the 2 cylinders causing it to become more hot. thats generally why that happens.
2 1/2 bolts and 1 brake line attached behind wheel cylinder, remove them and thats it sometome you may need to hit the cylinder with hammer to knock it lose.
vielside rx7 goes about 538mph thats how fast it goes because vielside uses 1234 horse power v8 engine doubled with n20 to make it more faster.
replaced the ECU thats the problem.