Want this question answered?
the return line is usually the one smaller in diameter.
Measure the distance from top left corner of square (or top right) to the bottom right corner of square( or bottom left) to get the diameter of the circle. Then calculate the circumference from that figure.
A number on top, with a smaller number on bottom
A rectangular frustum.
diameter: you have stated that it is 3.14 radius: half the diameter, therefore 1.57 circumference: pi times the diameter, therefore 3.14 x 3.14 = 9.86 area: pi times the radius squared, therefore 3.14 x 2.46 = 7.72
A butt weld is where the diameter of the pipes welded together are the same, a socket weld is where a larger diameter pipe is fitted into a smaller one. In making a butt weld, the pipes (or pipe and fitting) usually have an angle machined or ground into the outside corner, so when they are placed together face-face, there is a circumferential V shaped gap serving as the weld prep. In a socket weld, the pipe is inserted into the socket, backed off slightly to make a gap between the end of the pipe and the bottom of the socket, and the weld is made around the outside diameter of the socket to the outside diameter of the pipe. The gap at the bottom of the pipe prevents thermal expansion from stressing the joint during or after welding.
The diameter of the "cup" is the same top to bottom. There is, however, a slight beveled edge which makes the ball sit in the middle of the cup making it easier to retrieve by the golfer.
Generally the nominal diameter of cylinder bore is kept little smaller at cylinder head than at the bottom. The engine head will be generally heat and it tends to expand for these high temperatures. To prevent the bore diameter at head to exceed diameter at bottom,piston engine bore is ground with a slight choke.
If you mean wolves' teeth, there are four. Two big ones at the top in the front, and two slightly smaller ones at the bottom in the front.
Diameter is 28 inches
the return line is usually the one smaller in diameter.
The pressure at the bottom of a column of water depends on the height of the column, not its diameter. The pressure increases with increasing depth due to the weight of the water above. So, a taller column will result in higher pressure at the bottom.
It is located in the liquid line connection tube at the evaporator. (Lower, smaller diameter, tube connector at bottom of evaporator). The accumulator / drier usually needs to be removed to gain access.
The hepatic artery in the liver enters from the bottom and is much smaller in diameter than the aorta or the portal vein that it lies above. The hepatic vein exits the liver from the top, carries blood through the top portion of the liver, and is larger in diameter than the hepatic artery.
Graduated means diameter is not uniform top to bottom.
A proper fraction has the top number (the numerator) smaller than the bottom number (the denominator).
To wrap a piece of paper around a cylinder with a base diameter smaller than its top diameter and keep the paper flush against the cylinder, you can make a slit along one side of the paper from the edge to the center. Then, overlap the edges of the cut and tape or glue them to create a conical shape that matches the slant of the cylinder. This will allow you to wrap the paper smoothly around the cylinder.