18
Fill 7L and pour into 6Lthere will be 1L left over in 7Lpour 1L into 6L and refill 7Lpour 7L into 6L and what is remaining in 7L is 2Lrepeat for all 5L.
If you have an air compressor all you have to do is conect a tire inflator to the air hose fill it a little bit check it with a tire gauge and repeat until you have it filled to the recommended psi. If you don't go to the gas station andfill it in the same procedure.
Assuming an unlimited supply of water, fill the 4 l. pour that onto the 9l. refill the 4l and pour that in the 9l. it now has 8l (not full) fill the 4l again pourinr carefully into the 9l leaving 3l in the 4l container. empty the 9l. pour the 3l from the 4 in to the 9l container. Refill the 4l. Pour that into the 9l (4+3 =7). fill the 4l again and pourinto the 9l leaving 2l in the 4l container. Dump the 9l container, pour in the 2l from the 4l container. fill the 4l again. pour into the 9l (2+4 = 6) and you are finished.
6 times 950 liters / 150 liters = 6.33 times = 6
To refill a Bic Velocity pencil, simply pull off the eraser and refill with Bic Velocity Lead or any 0.7 mm lead. Then replace the eraser and you're ready to write again.
Take the top off and remove the eraser - most likely there are extra lead refills inside.
This actually got me for a while too. Take the eraser out of the top of the pencil and drop refill pencil graphite down the tube.
This actually got me for a while too. Take the eraser out of the top of the pencil and drop refill pencil graphite down the tube.
When an eraser is rubbed with wool, it gains a small negative charge due to the movement of electrons between the two materials. This static electricity doesn't usually attract paper, but it can help remove eraser residue from the paper due to an electrostatic effect.
Yes, Bic Velocity pencils can be refilled. One needs to remove the eraser part and fill in the new lead cartridge. If the eraser part is to worn, or completely worn off, it may prove impossible a task.
To refill a Papermate Clickster 0.5mm lead mechanical pencil, simply pull off the eraser to access the lead refill chamber. Insert the new lead into the chamber, replace the eraser, and you're ready to go.
To refill a glass mechanical pencil, first remove the eraser and any remaining lead. Insert new lead into the pencil's lead reservoir, making sure it is the correct size and fits securely. Reassemble the pencil and test to ensure the lead advances properly.
I think the Punto has electric power steering, so no fluid.
Refill is a noun (a refill) and a verb (to refill).
Push the eraser cap down and hold it down. This opens the mechanism so that you can drop the leads into the barrel of the pencil. When the lead is loaded, release the cap and click the lead into place.
It depends on the capacity of the battery pack the measurement is measured in kilowatts per hour just like how you would receive from the electric companies.Additional answerIf you think about it, the question is much like one that said 'how many gallons would a petrol car need at a refill?' How big is the tank and how empty is it when the refill starts?