Between 3 and 4 on the inches side. Inches may be divided into 10ths or 16ths but you will certainly not have a ruler that gives thousandths of an inch.
2.3 2 is two wholes, which go on the left side of the decimal, and 3/10ths is .3 because the first decimal place to the right is 10ths. Hope I helped!
In general, measure each side and add the measures together.In general, measure each side and add the measures together.In general, measure each side and add the measures together.In general, measure each side and add the measures together.
Any "straightedge" whether it be the side of a book, piece of paper, etc. can be used to create a straight line. Rulers, are common straightedges, as they are tools specifically meant to draw and measure lines.
-- Measure or calculate the length of one side. -- Measure or calculate the length of another side. -- Measure or calculate the length of the only remaining side. -- Add the three numbers. The sum is the perimeter of the triangle.
Between 3 and 4 on the inches side. Inches may be divided into 10ths or 16ths but you will certainly not have a ruler that gives thousandths of an inch.
these are the ancient ways: using pi using a ruler using the side of your hands to measure compass
5/16ths of an inch. So, 64 crayons lined up side by side would be 20 inches wide exactly.
2.3 2 is two wholes, which go on the left side of the decimal, and 3/10ths is .3 because the first decimal place to the right is 10ths. Hope I helped!
There are measurements smaller than a meter. There is the centimeter (cm), milimeter (mm), and micrometer (um). They can use many different things to measure objects. Most rulers come with inches along one side and centimeter/milimeters along the other.
In general, measure each side and add the measures together.In general, measure each side and add the measures together.In general, measure each side and add the measures together.In general, measure each side and add the measures together.
Any "straightedge" whether it be the side of a book, piece of paper, etc. can be used to create a straight line. Rulers, are common straightedges, as they are tools specifically meant to draw and measure lines.
measure from the middle out to one side
Side X SIde
angle with the greatest measure
you measure the computer screen diagonally, so if you have a 17" computer screen, and you measure it straight from side to side, then its not 17". You have to measure diagonally. I.e. Top left coner of the screen ( do not include the housing) to the bottom right side of the screen
You can take a tape measure from the out side and measure it from side to side and from bottom to top so you have a even measurement so it will look even when you are done.