Because the bottem mirror which is set and 45 degrees the light bounces off of and goes up at exactly 90 degrees that light then bounces off the top mirror and out a hole for you to look through.
At angle of 30 two mirrors will give nine reflected images.
It does not need to be. It can be smaller or larger.
a 90 degree, improve this answer if you need to, im fine with it....
You'll also need a protractor to construct a 220 degree angle which can then be bisected by means of a compass and a straight line to form two 110 degree angles.
Each exterior angle is 45 degrees (interior angle = 135 degrees).
To make a basic periscope, you will need two small mirrors, a sturdy cardboard tube or box, scissors, tape, and a ruler. Cut the cardboard tube or box into periscope shape, attach the mirrors inside at a 45-degree angle, then use tape to secure. Adjust the mirrors until you achieve the desired reflection.
To make a simple periscope, you will need two small mirrors, a sturdy cardboard tube or box, tape or glue, and a cutting tool. Cut holes at each end of the tube/box for the mirrors to fit into at a 45-degree angle. Secure the mirrors in place with tape or glue.
To make a periscope that allows you to see behind you, you will need two small mirrors, a cardboard tube, and some tape or glue. Place the mirrors at a 45-degree angle inside each end of the tube, ensuring they reflect the view behind you. Look through one end of the periscope while holding it up to see the rear view.
The instrument used in submarines to observe the surface of water is called a periscope. A periscope consists of a long tube with mirrors at each end, allowing the viewer to see objects above the water's surface while the submarine remains submerged. The periscope's mirrors reflect light from the surface down the tube to the viewer, providing a view of the surroundings without the need to surface the submarine.
Old trench periscopes worked by using two mirrors to bounce light from one place to another. A typical periscope uses two mirrors at 45 degree angles to the direction one desires to see. The light bounces from one to the other andthen out to the persons eye.If there is an object in front of you, any nearby light source (i.e the sun, a lamp etc.) bounces straight rays of light onto the object and then into your eyes, enabling you to see it. However, if the object is not within straight lines of your eyes, the light will not find them and you will not be able to see the object (since light only travels in straight lines).But a periscope works using the laws of reflection. Reflective objects like mirrors work by bouncing light so it carries on in a straight line but alters it's route, according to the angle of the mirror to the light source. This means that if the mirror was at a 45 degree angle to the light source then it would bounce off at a perpendicular (90 degree) angle. That is how a periscope works.The important fact to note when considering a periscope is that the laws of reflection mean that the light hitting a mirror at an angle is reflected off at twice the angle of the mirror. Thus a 45 degree mirror reflects light rays through 90 degrees.Submarine PeriscopesSubmarine optical periscopes don't use mirrors due to their fragility and susceptibility to environmental conditions/changes, requiring special coatings. Instead, they use refractive prisms.The newer U.S. Virginia-class and British Astute-class boats use neither; they use a Photonics Mast, which is essentially a hi-resolution camera array that is raised above the waterline. This has many advantages, the primary one being that the Control Room need not be directly under the main sail as in all previous modern submarine designs.
Periscope uses two mirrors to reflect and redirect the light from the object being viewed. The first mirror at the bottom of the periscope reflects the light from the object up towards the second mirror at the top, which then reflects the light towards the viewer's eye. This arrangement allows for the object to be viewed from a different vantage point without physically moving.
A periscope uses mirrors to reflect light, allowing you to see objects that are not in your direct line of sight. When you look through a periscope, you are essentially looking at the reflection of the object rather than directly at it. This design helps in situations where visibility is obstructed or when you need to remain hidden from view.
I need to know how to find each angle measured to the first degree. Such as: Sin B= 0.4848
At angle of 30 two mirrors will give nine reflected images.
What you need:2 mirrors (approx. 2" by 1", but other sizes work well too)a piece of carton (approx. 6 1/2" wide, 8" long. Or roughly 3 times the width of your mirrors and 4 times the height)ScissorsGlueSome paint to give it a nice spy look!How to make the periscope:Draw the lines on your carton as you see them on the plans. Note that there are dashed lines, these are fold lines, don't cut through those. The full lines are cut lines, use scissors to cut through those.Paste your mirrors on the spots where it says "mirrors".Fold the carton into a box. One mirror is looking up, the other one is looking down. Paste it so it stays box shaped.Fold the mirrors in so they are roughly in an angle of 45 degrees. Then fold the side flaps in and paste it to the back of the flap. Both sides!You have a working periscope now! Look through the lower mirror, and you can see much higher... over a wall, for instance. Or around a corner!Now give it that tough spy look by giving your new apparatus a couple of coats of paint. Think how it should look to blend in with the background. Green and brown is nice for the bushes, bad for the snow! two mirrors parallel to each other but at 45 degrees to the axis of a tube connecting them. Cut entry and exit holes in the tube to be able to see through.See image under Sources and related links below:
Two 90 degree angles create a perpendicular angle. A 60 degree angle and 120 degree angle also create a 180 degree sum.
A simple mirror will allow you to see around a corner, but to see above an object or wall, you need two mirrors aligned in a certain way. See the related link below for more information and some very helpful diagrams.