0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How many 9 inch diameter balloons could 11 gallons of 125 PSI air fill?
The answer depends on the pressure inside the balloons.
How many gpm of water at 140 psi will flow through a 0.75 inch diameter pipe?
What schedule piping as schedule 40 fittings are rated for 125# thus your 140 PSI would be really dangerous to try on standard fittings
350 Chevy not running on all cylinders?
Start by testing the compression. It should be consistent within a few PSI on each cylinder. Any cylinders that have little or no compression probably have a burned valve. If all cylinders are up, check the plugs, wiring and distributor.
How much does a 6 by 8 by 16 cinder block weigh?
The standard 6 by 8 by 16 cinder block weighs 28 pounds. They have a compression strength of 1900 psi.
How many psi can the pressure rise without reaching the emergency pressure limit if the pressure of the emergency limit is 86 percent and the limit is 93 psi and the pressure is measured in 0.1 psi?
limit is 86% of 93 psi = 86/100 x 93 psi ≈ 79.98 psi As the psi is measured to the nearest 0.1 psi, the safe limit is a measured 79.9 psi.
What is the compression psi on a 1990 engine?
Normal compression on a gasoline engine is about 125 psi.
What the compression for cylinder for 2000 dodge neon?
100-125 psi
What should the compression be on 94 Chrysler town and country 3.8L V6?
Around 100 - 125 psiAround 100 - 125 psi
What should the compression be on a 1997 dodge avenger?
125 psi approximately.
What is the compression specs for 1999 sebring convertible with 2.5 v6?
Approximately 125 psi, all within 25%.Approximately 125 psi, all within 25%.
What is a good compression on an old 2hp engine?
85-125 psi is acceptable.
How much compression does a 1999 2.4L sunfire gt supposed to have in psi please?
around 125 psi per cylinder
What is the compression for a polaris 250 2cycle?
your compression should be around 125-135 psi. for a 250cc polaris trailboss or trailblazer.
What is average compression test reading for a Plymouth neon 2001.?
100-125 psi
What would be an average compression test reading for a Chrysler 2.2?
100-125 psi
What is the compression for a 2001 pt cruiser 2.4 engine?
All should be around 125 psi plus or minus 25%All should be around 125 psi plus or minus 25%
What should the compression read on a 3.8 2000 Chrysler 2000 t and c?
125 psi
