the plasticity index decreases with increase in percent of fly ash because the hydraulic conductivity ( k) goes on increase
Inflation
A(m)/A(c)=0.5 is known as 50% modulation index. where, A(m)=amplitude of message signal A(c)=amplitude of carrier signal
It's 1/0.8 = 1.25
uses of index
yes , if the light travel from less density to more density the speed will decrease , the direction will change depend on the entered angle
The plasticity index is a measure of the plasticity of a soil, indicating the range of water content over which the soil behaves as a plastic material. It is calculated as the difference between the liquid limit and the plastic limit of the soil. Soils with a higher plasticity index are more prone to volume changes with changes in moisture content.
The plasticity index (PI) is a measure of the plasticity of soil, specifically indicative of the range of moisture contents over which the soil behaves plastically. For sand, which typically has little to no plasticity, the plasticity index is usually zero or very close to it. This is because sand particles do not adhere to each other when wet, unlike clay, which can swell and shrink significantly with moisture changes. Consequently, sands are generally classified as non-plastic.
fales
To find the percent change, you first subtract the earlier index value from the later one, then divide that difference by the earlier index value, and finally multiply the result by 100
Inflation
Increase lean muscle mass, reduce fatty tissue. Need a combination of Aerobics and weights.
To increase the IMA (Index of Machine Ability) of a screw, you can increase the thread pitch or decrease the head diameter. Both of these adjustments will increase the mechanical advantage of the screw, making it easier to drive and increasing its efficiency.
Hold clock button and volume increase or decrease to index hours of minutes.
As temperature increases, the average kinetic energy of the atoms or molecules in the material also increases, causing them to vibrate more. This increased vibration disrupts the regular arrangement of atoms or molecules, leading to a decrease in the speed of light within the material, and therefore a decrease in refractive index. Additionally, the increased thermal motion results in more collisions between photons and particles, which can further decrease the refractive index.
Chicken. Most people do not buy caviar. So the total amount spent on chicken is much greater than the total spent on caviar (even though caviar is more expensive). Therefore, in terms of the basket of consumer shopping, chicken is much more important had has more weight in the price index. This means an increase in the price of chicken will have a much greater impact on the index as the same percentage increase on caviar.
The wavelength of the wave can change as it passes into Medium 2, depending on the refractive indices of the mediums. If the wave enters a medium with a higher refractive index, the wavelength will decrease. If it enters a medium with a lower refractive index, the wavelength will increase.
When the temperature increases, the molecules in a substance begin to vibrate more rapidly. This increased molecular motion disrupts the regular alignment of molecules, causing a decrease in the refractive index. This disruption reduces the ability of the substance to slow down and bend light, resulting in a lower refractive index as temperature increases.