Q: Write 2 numbers between 1 and 2 use decimal?

Write your answer...

Submit

Still have questions?

Continue Learning about Math & Arithmetic

You use short division for decimals by whole numbers, then replace the decimal point in between the numbers, the answer is 15.0

Almost all numbers that we use in daily life are decimal numbers. The place value of each digit is ten times the place value of the digit to its right. And that is all that is required of decimal numbers. A decimal point is not necessary.

7.5462 x 10^4 Place a decimal after the first digit, in this case 7. Then count the number of digits following this decimal. There are 4 numbers following the decimal. Use this number as the power on the ten.

Any time: there is no restriction.

You can use int i; for (i = 10; i <= 50; i += 2) {//print i} as a program to print even numbers between 10 and 50.

Related questions

It separates the numbers

Decimals are used to describe parts of a number, something in between two whole numbers. Tenths, halves, eights etc. But 108 is only whole numbers, so there's nothing there to use a decimal for.

You use short division for decimals by whole numbers, then replace the decimal point in between the numbers, the answer is 15.0

Both base 16 and base 2 number systems use binary numbers (1 and 0) to write out and define decimal numbers.

Prime numbers are prime numbers - whether we count in the decimal, binary, hexadecimal or another base.

Decimal numbers are real numbers. In C and C++ we use the float, double and long double data types to represent real numbers.

2.151, 2.152, 2.153

Most of the time, chemists deal with extremely large or extremely small numbers. They use scientific notation to conveniently write these numbers in decimal form.

Binary can only be 1 & 0. Decimal numbers have a dot in them. Binary numbers use only 2 symbols (0 and 1) to represent different numbers, while decimal numbers use 10 symbols (0 to 9) to represent different numbers. check the below link for more.

Almost all numbers that we use in daily life are decimal numbers. The place value of each digit is ten times the place value of the digit to its right. And that is all that is required of decimal numbers. A decimal point is not necessary.

That will depend on the nature of the numbers. If there are no decimal places, you could use a right tab. If there are decimal places, you could use a decimal tab. If the numbers will all have the exact same amount of digits, then you could use a left, decimal or right tab.

7.5462 x 10^4 Place a decimal after the first digit, in this case 7. Then count the number of digits following this decimal. There are 4 numbers following the decimal. Use this number as the power on the ten.