A coil of wire acts as an inductor; it will have a very small resistance, and a relatively large inductance. Power factor is effectively the resistance divided by the impedance (made up of resistance and inductance), so the larger the inductance relative to the resistance, the lower the power factor will be.
parliamo </ SPAN> tienes </ SPAN> todas </ SPAN> Obtener </ SPAN> Todas </ SPAN> las </ SPAN> del </ SPAN> dragón, </ SPAN> menos < / SPAN> de </ goten </ SPAN> q tiene </ SPAN> q ser SPAN> </ SPAN> nivel </ SPAN> Obtener 100 </ SPAN> todas </ SPAN> y despues </ SPAN> SE </ SPAN> solitario Aparece </ SPAN> en el </ SPAN> pueblo, hablar </ SPAN> con el </ SPAN> cura </ SPAN> del </ cs_misspelled> SPAN> </ SPAN> ai </ cs_misspelled> SPAN> </ SPAN> hacia </ SPAN> donde </ SPAN> esta </ SPAN> el </ SPAN> Guardia </ SPAN> habla </ SPAN> y pasas </ SPAN> La Puerta </ SPAN> class=cs_misspelled> y la ha </ SPAN> derrotar </ span> volver </ SPAN> broly </ span> cn </ SPAN> hablarcura </ SPAN> del </ SPAN> Pueblo
A span is usually a measurement of length, as in inches or feet, not of time. However, some fantasy novels etc uses span for time; A span is an eleven day week.
Arm span is a measure of the arm
The COIL HAS A POSITIVE AND A NEGATIVE TERMINAL. If you look at the top of the coil, it is generally marked + and - on the top.
factor's which influences span of control. factor's which influences span of control.
factor's which influences span of control. factor's which influences span of control.
The Q factor of a coil, sometimes called the unloaded Q factor, is the ratio of the energy stored in the coil to the energy dissipated in the resistance of the wire.
the quality factor for choke coil is impedence divided by resistance in a given circuit
DL = lane distribution factor, expressed as a ratio, accounts for the distribution of loads when two or more lanes are available in one direction
impedance/resistance
main bars are those bars which lying on the shorter span : main bar formulas : Long span divide by distance of main bars puls one = Long span/distance of main bars +1 main bar lenght= (short span+hooks)-C.C C.C= concrete cover Distribution bars which is those lying on the longer span: No's=long span divided distance of main bar plus one=long span/distance of main bar+1 distribution bar length =(short span +hooks) -C.C c.c = is concrete cover
The Q factor (quality factor) of a coil is a measure of its efficiency in storing energy and transferring energy to a load. It is calculated as the ratio of the reactance of the coil to its resistance. A higher Q factor indicates lower energy losses in the coil.
Bypass factor is the percentage of air that travels through a tube and fin coil without touching any coil surface.
The key factor in describing population distribution is the land resources available. This is what will determine the population density of a place.
The factor that prevents an organism or population from reaching its full potential of distribution or activity is called the limiting factor.
water