angle modulation is called non linear modulation because the information is stored in phase of the carrier signal
Digital Signal Processing
The differences between the these two is that linear scale shows the relation between the map distance and the ground distance. The nonlinear scale do not show the relation between the map distance and the ground distance.
since the diode shows its characteristics in a non linearly it is called as nonlinear element since the transistor shows its characteristics in a linear way it s called as linear element Transistors are typically operated in their linear region (such as when used in amplifier circuits), or as switches (where you will in general ignore the nonlinearity of the transistor). Transistors are typically DC biased to operate in this linear region. Diodes are not biased in this way. Strictly speaking, both are nonlinear devices, although transistors can be used in their linear operation region, while diodes are not.
Inductor is a nonlinear device. since v=L di/dt.
Nonlinear devices are components that do not follow a linear relationship between input and output. This means that their response is not proportional to the input signal. Examples include diodes, transistors, and nonlinear capacitors. Nonlinear devices are often used in electronic circuits to perform functions like signal processing and modulation.
Signal processing and linear systems by B.P LATHI
The amplifier is supposed to be an electronic circuit. Electronic circuits are nonlinear circuits, which may be modeled in the time domain by means of nonlinear differential equations and nonlinear algebraic equations. The kernel of the solution of the nonlinear equations is the solution of a linear equation system i.e. the nonlinear components and couplings are approximated with linear relations valid for small signals. Iterations are performed until the laws of Kirchhoff are fulfilled. The instant set of linear equations is the small signal model for the amplifier. If the amplifier is excited with a dc power source it assumes an active state called the bias point or quiescent point. If the relation between the input and the output signals of the amplifier is measured to be (almost) linear in the bias point then we assume a small signal amplifier with time independent bias point else we assume a large signal amplifier.
linear (A+)
linear
linear
ssfdggfdhgjghghgfhg
angle modulation is called non linear modulation because the information is stored in phase of the carrier signal
Yes, the rate of change can be linear or non-linear.
It is linear.
This is non-linear
6 is neither linear nor non-linear. It is just a number.