Just simply, connect all the black wires to the black wire coming out of the connector, and all the white wires to the white wire coming out of the connected. Use the blocks with screw in to connect them (pick them up from most car accessories shops like halfords, wilcos....etc).
A black and white single wire in a ceiling fan is typically used for connecting the fan's light kit. The black wire is for connecting the live/hot wire, which powers the light, while the white wire is for the neutral wire, completing the electrical circuit. It's important to follow the manufacturer's instructions when connecting the wires to ensure proper installation and safe operation.
If there are two black wires, it's possible that it was wired for a ceiling fan and that one of the wires is for the fan part while the other is for the light part. If so, one of the black wires may be switched while the other is always "on." Normally black is "hot" and white is "neutral" (NOT ground... ground is usually green).
Connect the black wire from the switch to the black wires of both lights. Connect the white wires together. Connect the red wire, if used for the motion sensor, to the black wires on the lights. Connect all ground wires together and to the ground terminal on the switch. Make sure to turn off power before connecting any wires for safety.
More information is needed as to what device you are connecting to what power supply. The only two identifiable wires are the white and green. In North America the white colour is used for the circuit's neutral and the green is used for grounding of devices.
You would have to provide more info to be certain what your problem is. Typically a black and white wire would connect to the two wires on the light fixture. The fixture should also be controlled by a switch that "breaks" the black (Hot Wire) to turn off the fixture. If you have a volt meter you can see if there is 120Volts between the black and white wires with switch on. If there is a single white wire going to fixture (Neutral), where is the "black wires tied" to. Maybe one of the black wires has broken off the fixture.
The correct order for connecting the red, black, and white wires in an electrical circuit is typically red to black to white.
The correct order of connecting the red, white, black, and green wires in a circuit is typically red to black, white to green.
The proper sequence for connecting the black, white, and red wires in an electrical circuit is to connect the black wire to the live or hot terminal, the white wire to the neutral terminal, and the red wire to the switched or load terminal.
If you are connecting 120 volts, you connect the black wire to the breaker, white wire to the neutral bar, and ground wire to the ground bar. If you are connecting 240 volts connect the black & white wires to the breaker, & ground wire to the ground bar.
The correct order of connecting the red, black, and green wires in a circuit is typically red to positive, black to negative, and green to ground.
A black and white single wire in a ceiling fan is typically used for connecting the fan's light kit. The black wire is for connecting the live/hot wire, which powers the light, while the white wire is for the neutral wire, completing the electrical circuit. It's important to follow the manufacturer's instructions when connecting the wires to ensure proper installation and safe operation.
If there are two black wires, it's possible that it was wired for a ceiling fan and that one of the wires is for the fan part while the other is for the light part. If so, one of the black wires may be switched while the other is always "on." Normally black is "hot" and white is "neutral" (NOT ground... ground is usually green).
by connecting it with the red + black wires
In house wiring, the standard color code for identifying black wires is black, and for white wires is white.
Red= 12v Hot & Black is ground.
The color of the wires in the electrical circuit are green, black, and white.
The 3-wire plug diagram for connecting a new appliance to an electrical outlet involves matching the colors of the wires - green to green, white to white, and black to black. Make sure to follow the manufacturer's instructions and consult a professional if needed.