House wire is "line" Black & White House goes to Black & White of Timer;
the "load" (e.g. Pond Pump, etc.) is connected to the Red & White.
Specifically, put all 3 whites together (nut or terminal); House (source)(line) Black to Timer Black; and "load" Black to Timer Red. The Red wire is the "Timed" (switched) hot wire.
It seems like you are describing the Red, Black, White and Ground in your electric panel. There is 240 VAC between Black and Red and 120 VAC between Black and White and 120 VAC between Red and White. The electric panel has two busses that supply 120 VAC on alternating breakers in your panel. Essentially, the Red turns into "black" in the panel for all practical purposes. If you have a 240 VAC circuit it essentially takes up to two vertical positions in your electric panel.
To answer this question fully the type of appliance has to be stated and its voltage.
black should be your hot white your neautral and the red should be the interconnect to another smoke alarm so that if one goes off in the upstairs the down stairs one will go off also because they are joined by the red wire(interconnected) check for another smoke detector(the red/black/white)should be fed from it to were you are talking about
You will have to check to make sure. Normally, with 4 wires, the black and red are both power for 220. White for neutral and bare for ground. If you are only using one leg of it, you would use the black, white, bare ones and cap the red one. Someone may have used the 4 strand because they had it or 220 was planned but not done or both the red and black are hot. You should be able to tell in the panel. Do the red and black both connect to separate breakers or to one or is the red not connected?
Just simply, connect all the black wires to the black wire coming out of the connector, and all the white wires to the white wire coming out of the connected. Use the blocks with screw in to connect them (pick them up from most car accessories shops like halfords, wilcos....etc).
Yes, you can connect the light fixture wires to the house wires by matching the colors appropriately. The black wire from the fixture should connect to the red wire from the house, as both typically serve as "hot" wires. The white wire from the fixture should connect to the white wire from the house, which is the neutral. Finally, connect the ground wires (bare or green) together to ensure proper grounding.
It seems like you are describing the Red, Black, White and Ground in your electric panel. There is 240 VAC between Black and Red and 120 VAC between Black and White and 120 VAC between Red and White. The electric panel has two busses that supply 120 VAC on alternating breakers in your panel. Essentially, the Red turns into "black" in the panel for all practical purposes. If you have a 240 VAC circuit it essentially takes up to two vertical positions in your electric panel.
If you have a houseboat or an RV, the wiring is the same as a house. The black is the hot and it goes to the positive, the white is the neutral and goes to the negative. If you are not certain, contact the manufacturer of your watercraft.
To answer this question fully the type of appliance has to be stated and its voltage.
White House Black Market was created in 1985.
black should be your hot white your neautral and the red should be the interconnect to another smoke alarm so that if one goes off in the upstairs the down stairs one will go off also because they are joined by the red wire(interconnected) check for another smoke detector(the red/black/white)should be fed from it to were you are talking about
No, Pokémon White and Pokémon Black 2 cannot connect via the Extralink.
the motor should have two leads, usually a black and a white. connect the white to the fusebox and the black to a ground.
You will have to check to make sure. Normally, with 4 wires, the black and red are both power for 220. White for neutral and bare for ground. If you are only using one leg of it, you would use the black, white, bare ones and cap the red one. Someone may have used the 4 strand because they had it or 220 was planned but not done or both the red and black are hot. You should be able to tell in the panel. Do the red and black both connect to separate breakers or to one or is the red not connected?
the white house the white house
The white wire is typically used to connect an outlet.
This email is completely false. Just delete it. there is no Black in the White house or Black Muslim in the White House virus.