This is one way that can locate hidden circuit breakers. It is not the best way because an arc flash could result if the breaker does not trip. An arc flash can generate enough heat instantaneously to burn the flesh off of any exposed skin. If there is combustible products or combustible air mixture that is in the general location of the arc, a fire could be easily started. The way that I do it is to load the circuit. I have a 3000 watt heater that I plug in to the circuit that I am trying to locate the breaker for. This loads the 15 amp circuit to 25 amps. The circuit breaker is located in a few seconds.
No, it is not recommended to replace a 35 amp breaker with a 40 amp breaker for an AC unit. Breakers are designed to protect the circuit and the equipment, so using a higher rated breaker can lead to overheating and potential damage. It is best to use the correct amperage rated breaker for the equipment.
No, it would not be safe because 250v is too high for that breaker. <<>> In North America all household breakers are rated at 120/240 volts. A 250 volt 15 amp breaker would would be a two pole breaker and take up two slots in the distribution panel. This can be pulled out and replaced with two separate 15 amp breakers or one 15 amp breaker and a slot panel filler to cover the second slot.
Yes, but you need a power source, for the shunt trip coil voltage, in the circuit.
No, you cannot install a 2x20 amp breaker if the total amperage of all the breakers exceeds the main breaker rating, as this would overload the system. The total amperage of the breakers should not exceed the main breaker rating to ensure safe operation of the electrical system.
You can't because they suck in light, there for you cannot see them
No, it is not recommended to replace a 35 amp breaker with a 40 amp breaker for an AC unit. Breakers are designed to protect the circuit and the equipment, so using a higher rated breaker can lead to overheating and potential damage. It is best to use the correct amperage rated breaker for the equipment.
No, you cannot get warts from touching a frog. Warts are caused by a virus that infects the skin, not by touching frogs or other animals.
50amp but if considering the breaker cannot withstand starting current you need to size the breaker up.
No, touching a frog cannot give you warts. Warts are caused by a virus that infects the skin, not by touching frogs or other animals.
no you cannot
No, you cannot get a wart from touching a frog. Warts are caused by a virus that infects the skin, not by contact with frogs.
temperature cannot be used to identify a type of matter.
You cannot use just weight to identify a material.You can use density to identify materials.
You cannot make a spark by touching a wooden door as wood is not conductive. However, you can create a spark by touching a metal doorknob if you build up static electricity, such as by shuffling your feet on a carpet.
No, it would not be safe because 250v is too high for that breaker. <<>> In North America all household breakers are rated at 120/240 volts. A 250 volt 15 amp breaker would would be a two pole breaker and take up two slots in the distribution panel. This can be pulled out and replaced with two separate 15 amp breakers or one 15 amp breaker and a slot panel filler to cover the second slot.
What is 'this'? We cannot see 'this' to define or identify it.
Cannot is correct.