A #10 copper wire with an insulation rated at 90 degree C has a rating of 30 amps. Over the distance of 12 feet, there is no appreciable voltage drop that will effect the load.
The ampacity or amp rating of all wire is rated by the size of the wire. NM (non-metallic sheathing) wire is no different. In household wiring 14 gauge wire must go on a 15 amp breaker/ 12 gauge goes on a 20 A and 10 gauge goes on a 30 Amp.
No, it is not safe to use 10 gauge wire with a 30 amp breaker as the wire is not rated for that high of a current. It is important to use the correct wire gauge that matches the breaker amperage to prevent overheating and potential fire hazards. For a 30 amp breaker, you should use at least 10 gauge wire.
No, you should not use 10 gauge wire with a 30 amp dryer. A 30 amp dryer requires a minimum of 10 gauge wire, but it is recommended to use 8 gauge wire to ensure safety and to meet electrical code requirements. Using 10 gauge wire may cause overheating and pose a fire hazard.
12 guage wire israted for 20 amps and 10 guage is rated for thirty amps! 12 gauge is what is required, as it is rated for 20 amps. 10 gauge is rated for 30 and will be more then enough. Oversizing wire in your case isn't necessary. The thicker 10 gauge wire is harder to work with and will more then likely cost more.
I wouldn't, always safer to go heaver gauge. I recommend 8 gauge if you are going to be running any length of wire. Fire is never fun I believe the above answer assumes the question was meant to read, "30 amp 220 volt dryer." 12 gauge wire WILL NOT carry 30 amps safely. You need to run #10 copper minimum. It is never a bad idea to upsize, such as the recommended #8, but it is not necessary if 30 amps is what you need.
The recommended gauge of wire for a 30 amp circuit is typically 10 AWG (American Wire Gauge).
The recommended wire gauge for a 30 amp circuit is typically 10 AWG (American Wire Gauge).
For a 30 amp breaker, a 10-gauge wire should be used.
The recommended wire size for a 30 amp circuit is typically 10 gauge wire.
The recommended gauge for a 30 amp wire in a residential electrical installation is typically 10 AWG (American Wire Gauge).
A 30-amp circuit breaker is typically suitable for 10-gauge wire.
No, 10 gauge wire requires the use of a 30 amp breaker. A 20 amp breaker is only used on 12 gauge wire.
The ampacity or amp rating of all wire is rated by the size of the wire. NM (non-metallic sheathing) wire is no different. In household wiring 14 gauge wire must go on a 15 amp breaker/ 12 gauge goes on a 20 A and 10 gauge goes on a 30 Amp.
The recommended wire size for a 30 amp circuit is typically 10 gauge wire.
The appropriate wire size for a 30 amp breaker is typically 10 gauge wire.
The appropriate wire size for a 30 amp circuit is typically 10 gauge wire.
The recommended wire size for a 30 amp breaker is typically 10 gauge wire.