12 AWG in most circumstances.
For a 20 amp 220 volt electric motor, you would typically want to use a wire that is rated for at least 12 AWG (American Wire Gauge) to ensure proper power transmission and safety. It's always best to consult local electrical codes or a certified electrician to ensure compliance and safety.
i have 200 hp motor what i need cable size in 100 feet distance
The breaker size for a 10 KVA electric heater would depend on the voltage it operates at. For example, for a 240V heater, you would need a 41.67 Amp breaker (10,000 VA / 240V = 41.67 A). It is important to consult with a licensed electrician to ensure the correct breaker size and electrical setup for your specific heater.
Yes, you can run a 220 volt 1 horsepower motor with batteries by using an inverter to convert the DC power from the batteries into AC power that the motor can use. However, the size and number of batteries needed will depend on the motor's power requirements and the duration for which you want to run it.
No, it is not recommended to run a 570 volt motor on a 480 volt power supply. The motor is rated for a specific voltage to ensure optimal performance and prevent damage. Running the motor at a lower voltage could result in overheating and premature failure.
It is not recommended to rewire a 120-volt motor to run on 220 volts, as it can damage the motor and pose a safety risk. It is best to purchase a motor designed to run on 220 volts to ensure proper functioning and safety.
4.5 volt battery sold only in Russo
....on an automobile it is a 12 volt DC motor. the electric cooling fan is driven from this type motor.....
i have 200 hp motor what i need cable size in 100 feet distance
The Chevy Volt uses gas to power an electric motor.
In a single phase 220 volt electric motor just measure one line. That already represents your line current. That line current is equal to your total current circulating in your motor.
If the motor wire numbers are L1, L2 and L3, it is not a single phase motor. It is a three phase motor. Also for future reference, a 220 volt single phase motor does not use a neutral.
That's a powerful motor, and would need a supply greater than 13 amps at 240 volts, also the conversion might be difficult. I have a feeling that you would be better off finding out how powerful a motor you would need for the task you have, then buying a suitable 240 volt motor. You are heading into territory where you should really consult a qualified electrician.
No. You need to rewire the circuit from the electric panel.
Go to the website of a motor starter manufacture, such as 'Square D'.
110v 40 uf
Depends on the electric motor, most models use the Mabuchi 540s which is rated from 6 volt - 8.4 volt. If that's fitted you should be OK!
If a 48 Volt club car electric motor requires 48 volts, then it should be given a 48 volt power source, or something close to it. Too many more volts and it may burn out; not enough volts and it may not run or it will try to draw too much power and burn out the power supply.