A #8 wire with an insulation rating of 75 or 90 degrees C is rated at 45amps respectively.
10 awg wire can have a breaker size of 30amps. It can actually carry more but as for codes the wire is usually allowed to carry 80% of its max capability which puts the breaker at a max size of 30 amps.
A 4 mm diameter copper wire with an insulation factor of 75 or 90 degrees C is rated at 65 amps.
I am assuming that this is a one and a half HP motor. To wire a 120V 20A motor the electrical code states that the conductor has to be 125% of the motor's full load amps. This equals 25 amps. There is no wire rated at 25 amps so the next size up is 30 amps. A #10 copper wire with an insulation factor of 60, 75 and 90 degrees C is rated at 30 amps. To carry this to a conclusion This #10 wire should be protected by either 60 amp non time delay fuses or 35 amp time delay fuses or a two pole 50 amp breaker.
You will need to use #8 wire.
The ampacity of a # 10 copper wire with an insulation factor of 90 degrees C is 30 amps. All wire voltage ratings usually drop into two categories 300 volts and 600 volts. Home wiring drops into the 300 volt range and commercial, industrial, drops into the 600 volt range.
The recommended wire size for a circuit carrying 35 amps of current is typically 8 AWG (American Wire Gauge).
The recommended wire size for a 35 amp circuit is typically 10 gauge wire.
The recommended wire size for a 35 amp breaker is typically 8 AWG (American Wire Gauge) for copper wire.
10 awg wire can have a breaker size of 30amps. It can actually carry more but as for codes the wire is usually allowed to carry 80% of its max capability which puts the breaker at a max size of 30 amps.
The amp rating for a number 10 wire is typically around 30 to 35 amps.
it would depend on the diameter of the cable
A 4 mm diameter copper wire with an insulation factor of 75 or 90 degrees C is rated at 65 amps.
I am assuming that this is a one and a half HP motor. To wire a 120V 20A motor the electrical code states that the conductor has to be 125% of the motor's full load amps. This equals 25 amps. There is no wire rated at 25 amps so the next size up is 30 amps. A #10 copper wire with an insulation factor of 60, 75 and 90 degrees C is rated at 30 amps. To carry this to a conclusion This #10 wire should be protected by either 60 amp non time delay fuses or 35 amp time delay fuses or a two pole 50 amp breaker.
A 35 sq mm copper wire with an insulation factor of 75 or 90 degrees C is rated at 115 and 120 amps respectively.
For a 150 amp service located 35 feet away, you typically need to use a minimum of 2 AWG copper wire or 1/0 AWG aluminum wire. It's important to consider factors like voltage drop, local electrical codes, and the specific application, which may require adjustments to wire size. Always consult with a licensed electrician to ensure compliance with safety standards and regulations.
#6 awg copper
You will need to use #8 wire.