This is a voltage drop question. To answer this question the voltage of the pump must be stated
The amp size of a wire is determined by its gauge, not the number of wires. An 8-gauge wire is typically rated for around 40-60 amps, depending on the type and insulation of the wire.
That can't be answered until you state the voltage.
For a 50 amp service over a 145 feet distance, it is recommended to use a 6 gauge wire to ensure proper voltage drop and safety. This wire size will help reduce resistance and prevent overheating of the circuit. Be sure to consult with a licensed electrician to confirm the appropriate wire size for your specific installation needs.
For a 30 amp circuit running 350 feet, it is recommended to use at least a 10-gauge wire to account for voltage drop over the distance. This heavier gauge wire will ensure the safe and efficient delivery of power over the longer distance.
12 AWG.
This is a voltage drop question. To answer this question the voltage of the pump must be stated
The amp size of a wire is determined by its gauge, not the number of wires. An 8-gauge wire is typically rated for around 40-60 amps, depending on the type and insulation of the wire.
That can't be answered until you state the voltage.
For a 50 amp service over a 145 feet distance, it is recommended to use a 6 gauge wire to ensure proper voltage drop and safety. This wire size will help reduce resistance and prevent overheating of the circuit. Be sure to consult with a licensed electrician to confirm the appropriate wire size for your specific installation needs.
For a 30 amp circuit running 350 feet, it is recommended to use at least a 10-gauge wire to account for voltage drop over the distance. This heavier gauge wire will ensure the safe and efficient delivery of power over the longer distance.
This is a voltage drop question. To answer this question a voltage must be stated.
Up to about 100 ft the size of the wire is determined by the max current and not the distance. A 90 amp supply needs #6 wire. <<>> A #2 copper conductor will limit the voltage drop to 3 percent or less when supplying 90 amps for 75 feet on a three phase 480 volt system.
For a 125 amp sub panel located less than 200 feet away from a 200 amp panel, you would typically use a 2 AWG copper wire or 1/0 AWG aluminum wire to safely carry the current load. It's important to follow local electrical codes and regulations when selecting the wire size.
A 30 amp breaker run 75 feet would require you use AWG #10 wire. But, an oven normally pulls more that 30 amps and I would not use #10 wire on a 30 amp breaker for an oven. Normally any newer oven is wired with AWG #6 gauge wire on a 50 amp circuit breaker so the breaker will not trip during heavy use of the oven. Some older ovens could use a #8 wire on a 40 amp breaker.
15 amps.
This is a voltage drop question. A voltage must be stated to answer this question.