It should be in the main circuit panel. If the dryer was added at some point there may be a separate box just for the dryer either beside the main panel or at the dryer plug. It is not in the dryer itself.
Chat with our AI personalities
The double 30 amp breaker for an electric dryer is typically located in the electrical panel or circuit breaker box of the house. It is used to provide the necessary power for the dryer to operate safely and efficiently. If you are unsure where it is located, it is recommended to consult with a qualified electrician for assistance.
If you are referring to a cloths dryer, the answer depends on the requirements of the dryer. Most dryers require AWG#10 wire with a 30 amp fuse. If the wiring is AWG#12 then use a 20 amp breaker but never use it on AWG#10 which requires a 30 amp breaker. If you are referring to a hair dryer then yes a 20 amp breaker is fine.
No. The two appliances usually have dedicated circuits. The range will have a two pole 40 amp breaker and be fed with a 3-C #8 copper cable. The dryer will have a 30 amp two pole breaker and be fed with a 3-C # 10 copper cable. As you can see by powering a 40 amp device from a 30 amp breaker, full operation of the range will trip the 30 amp breaker.
Yes, a single pole 30 amp breaker can be used for an electric dryer. However, it is important to verify the electrical requirements of the dryer and ensure that the wiring and outlet are also rated for 30 amps. If in doubt, it is recommended to consult with a qualified electrician for proper installation.
For a 120V hand dryer with a rating of 20 amps, use a 20 amp breaker to match the device's ampacity and prevent potential overloading or overheating issues.
Yes, you can use a 25 amp double pole breaker for a 240 volt heavy duty Whirlpool dryer. It is important to match the breaker size with the electrical requirements of the appliance to ensure proper function and safety.