My son has this assignment too. My understanding is that he needs to draw 10 lines, each one 10 centimeters long. For the first line, he must mark off the first centimeter and note that 10 centimeters is 1+9 centimeters. The second line is marked 2 cms off of the start and it is noted that 2+8 = 10 centimeters. This is done for all 10 lines. http://www.educationplace.biz/parents/mthexp/g2/letters/pdf/fl_g2_ual1_en.pdf
I'd prefer to draw it with a pencil.
It is impossible to draw a straight line.
We are not here to do your homework for you.
Draw any finite line. Write C near one end; write D near the other end. You now have a line segment and have named it CD.
To draw a line that is 2.4 centimeters, take a ruler with metric measurements and start your line at zero. Stop drawing until you get to the fourth line past the 2 centimeters mark. The line you will have drawn will be 2.4 centimeters.
7 cm line segament
Draw a right angled triangle with legs of lengths 2 and 3 units. The hypotenuse will be sqrt(13) units.
A rectangle with equal side lengths is a square.You draw one straight line segment of the required length. At each of its ends you draw a perpendicular, both facing in the same direction. Make these of the same length as well. Join the other ends of these perpendiculars.
How to do it
Same as a square, except the kite only occupies half the space. (Draw a picture if you have to.) So, 6x8 = 48, divided by two is 24 [sq. cm]
Use a protractor and get it to 2 centimeters and draw that circle.YOUR DONE ENJOY
Draw it with dimensions of (6 cm) by (3 cm).
Draw three whole circles and then draw a circle from which a quarter segment is cut out.
Take a compass, extend it about 3/4 of the length of the segment. Then from one end of the segment, draw a 180 degree arc. From the other end draw another arc. Connect the points where the arcs intersect. Where the line intersects with the segment is the midpoint of the segment. That is how you bisect a segment to find the midpoint - geometrically.
It stands for Multiple draw lengths. You can change the draw length, but you have to provide the modules to do so.
It is impossible to draw a straight line.
I'd prefer to draw it with a pencil.