0
1yrd of grout will fill 100 block with typical 32" on center vertical rebar and 48" horizontal rebar.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
How many pennies will it take to fill a 1.75 liter bottle?
30,000??
How much dirt would it take to fill a hole 2x3x4 feet?
24 feet
If you drill a hole 40 feet deep by 24 inches in diameter how much concrete will it take to fill it in?
18.6240 yd³
How many 750 ml bottles does it take to fill a gallon?
It would take approximately 5, 750 ml bottles to fill a U.S. gallon. eraofbusiness
How many holes does it take to fill albert hall?
Holes don't fill things up, they empty it
What colors does grout come in?
Depending on where you purchase the grout, you can actually have the grout colored to any color of your choice. Like paint, you can take in a color swatch and get the grout dyed to match the decor.
Why did my brown grout dry white?
All grout dries lighter when dry.but brown grout should not dry white. Check the date of; it might be passed its shelf life. look and see if you bought a light brown grout. You could cut the grout out with a grout rake but this would take ages
How much gas do it take to fill up 2009 dodge caravan?
how much gas does it take to fill up 2009 dodge caavan.
How many quarts of oil does it take to completely re-fill in the engine block of a 1999 Chrysler lhs?
Three.
How much oil do you put in a Lincoln town car?
Big block 5 US quarts 5.0L 5 US quarts 4.6L fill on left side, 5.25 US quarts 4.6L fill on right side, 5.75 to 6 US quarts, with some exceptions that take as much as 7
10x10x4inhow much concrete does it take to fill this?
1.2345 yards
How much gas does it take to fill a school bus?
A lot.
How much coolint does a s10 blazer hold?
If the whole system was empty, the radiator, the engine block, the heater core, all the hoses, it would take aprox 11 to 12 qts of coolant to fill the system.
How much transmission fluid to fill a Harley?
24 oz is what most take do not over fill or it will bust your seal
How much money does it take to fill a cruise ships tank?
60,000.00
How much time will you take to fill up a bathtub?
about 20 mins
How do you grout tiles?
It is somewhat painstaking. There is a grout removal tool available at most big box hardware stores. It is basically a handsaw that uses hardened aggregate applied to the blade instead of teeth. You have to shave each joint down to a level below the surface that a new grout can be applied to and adhere (about 1/8" for non-sanded grout and 1/4" for sanded grout). If you are changing grout colors, you will want to use an acid (muriatic acid) to wash down the joint edges to remove any small amounts of the old grout at the surface edge that remain, prior to new grout installation. Because you are not installing the new grout to the full tile depth, it is advisable to use a latex additive to prevent cracking.
