answersLogoWhite

0

5.50 Inches Wide

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

What is the recommended span for a 2x6 board?

The recommended span for a 2x6 board is typically around 8 to 12 feet, depending on the load it needs to support.


What is the maximum span for a 2x6?

The maximum span for a 2x6 board is typically around 10 feet when used as a joist or rafter in construction.


How far can you span a 2x6 without any additional support?

A 2x6 board can span up to 9 feet without any additional support.


How far can a 2x6 span without support?

A 2x6 board can span up to 9 feet without support, depending on the type of wood and the load it needs to bear.


How far will a 2x6 span without support?

A 2x6 board can span up to 9 feet without support, depending on the type of wood and the load it needs to bear.


How wide is a 2X6?

A 2X6 is 5 1/2 inches wide. Incidentally it's 1 1/2 inches thick. Pre-WWII lumber was cut at stated dimensions, a 2x4 was actually 2 inches by 4 inches.


How many 2x6 do i need to cover 196 square?

To determine how many 2x6 boards are needed to cover 196 square feet, first calculate the area of one 2x6 board. A 2x6 board is actually 1.5 inches by 5.5 inches, which converts to 0.125 feet by 0.458 feet, giving an area of about 0.0574 square feet. Dividing 196 square feet by 0.0574 square feet per board results in approximately 3,417 boards. Therefore, you would need about 3,417 boards to cover 196 square feet.


What is the correct name of a trim board that is normally applied to the lower edge of a sloping roof before the application of the surface material?

I am going to guess that you are talking about the fascia board which is usually a 2x6 board


If you buy 300 linear feet of 2X6 redwood decking how big of a deck can you make?

A nominal 2x6 baord is actually 5.5" wide. 5.5"/12"=0.45833ft => 0.45833ft x 300ft = 137.5 sq-ft


What is the actual size of a 2 x 6?

a "2x6" board is actually 1 1/2" x5 1/2"


How wide is 2x8 board?

At one time, sawmills cut green lumber to 2"x8". A higher-humidity board would shrink more than an dryer board, and in any case, the board would be reduced in size by planing (smoothing the rough-cut sides.) Seems to me that the industry standardized the size of wood about 40 yeas ago. Now, sawmills calculate the size to cut so that dried and planed wood will be a standard size when dried. A 2x6 is actually 1.5 inches thick and 7.25 inches wide.


What is the answer for 2x6?

12