The answer is Degree.
unit
radiation
Density is measured as mass per unit volume: not mass per unit area. Unless the material is of uniform thickness.Density is measured as mass per unit volume: not mass per unit area. Unless the material is of uniform thickness.Density is measured as mass per unit volume: not mass per unit area. Unless the material is of uniform thickness.Density is measured as mass per unit volume: not mass per unit area. Unless the material is of uniform thickness.
degrees
Resistance is measured in Ohms.Resistance is measured in Ohms.Resistance is measured in Ohms.Resistance is measured in Ohms.
Resistance is measured in ohms (Ω), named after the German physicist Georg Simon Ohm.
Ohm (Ω) is the unit that measures resistance to electrical current.
Ohms, resistance in an inductor increases as the frequency of the AC signal increases, this "artificial resistance" is called impedence, and it is measured in ohms
The unit of power measured is watt, irrespective of resistance, capacitance or inductance of the circuit.
Ohms. It can also be calculated using Ohm's Law. V=I/R where V is voltage in Volts, I is current in Amps, and R is resistance in Ohms.
Resistance is measured in ohms.By Ohm's law, resistance is voltage divided by current, which is (joules per coulomb) divided by (coulombs per second), which is joules-seconds divided by coulombs squared. (It is easier to just say ohms.)
The unit for measuring electrical resistance is called an Ohm. The Ohm is the unit used in the International System of Units (SI) and is named after George Ohm.ohms??The resistance of electricity is measured in units called ohms. A digital multimeter can be used to accurately measure ohms.The metric unit applied in measuring resistance is called the Ohm. Resistance is a scientific measure of how electron flow is opposed while flowing through a circuit.
The specific resisitivity - also called residual or inherent resistivity - of a particular material (scientifically called its specific resistivity) is measured in ohms per unit volume. It can be determined by measuring the resistance of a test conductor having unit length and unit cross sectional area or some other accurately-measured volume of the material.
Diodes are measured in terms of resistance. The formula is as follows Rd = Vd / Id. That is Resistance of the diode = voltage across the diode to current flowing throught the diode.
In a electronics schematic diagram, a resistor is symbolized by a zig-zag line. The unit of resistance is measured in ohms, written with the greek letter omega.
Ohm