So that the arc is mid-way in perpendicular to the line segment
On the basis of the information provided, kn can be any length greater than 2.5 cm. There is nothing in the question that requires either n to be on kl or for kl to be the bisector of mn.
An obtuse triangle is a triangle with one angle greater than 90 degrees. Since a perpendicular side is a side that forms a right angle with another side, an obtuse triangle can have 0 perpendicular sides if all its angles are obtuse. However, it can also have 1 perpendicular side if one of its angles is a right angle.
Equilateral triangle * * * * * Why? Draw an arc, greater than half the distance of the line segment, from one of the end points. Another arc, using the same radius from the other end. Jion the two points where the arcs intersect - one on each side of the line. At best you get two isosceles triangles if yu join up other lines (which is not required), but certainly no equilaterals! ******* because it's APEX and it's stupid in ways you can't understand
It is greater!It is greater!It is greater!It is greater!
0.575 is greater than 0.1069
Open the compass to a width greater than half the length of AB.Place the compass point at A.Draw arcs above and below the line AB.Move the compass point to B WITHOUT changing the compass setting.Draw arcs above and below AB to intersect them at X and Y.Join XY.XY is the perpendicular bisector of AB.7. Celebrate the successful completion of the task!
yes
The compass as this allowed greater trade options not just for the Chinese but the world in general
The compass as this allowed greater trade options not just for the Chinese but the world in general
On the basis of the information provided, kn can be any length greater than 2.5 cm. There is nothing in the question that requires either n to be on kl or for kl to be the bisector of mn.
Start by drawing any angle greater than 90 degrees, and then connect the endpoint of the rays that create you angle.
The two indentations in the pivot of a plotting compass allow for greater stability and precision when drawing circles. The indentations reduce friction and ensure that the compass point stays in place while drawing curves. This design feature helps to create smooth and accurate circles.
The area of a parallelogram is base times perpendicular height With the dimensions given the perpendicular height of the rectangle will be greater than the parallelogram. Therefore the rectangle will have a greater area than the parallelogram.
the perpendicular force applied at the end of a wrench handle. Because torque= Fd / T = F d cos θ therefore the greater the distance the greater the torque. T=torque F=force d=distance cos=cosine θ=theta
Not necessarily. Work is the product of force and displacement in the direction of force. If the force is applied but there is no movement or displacement, then no work is done. So, a greater amount of force does not always result in a greater amount of work if there is no displacement.
With a straight edge and making sure that its length is greater than its perpendicular height and that opposite sides are parallel to each other.
It is in the stair-waist from the bottom with min. covering of 15 mm. or equal to the dia. of the main reinforcement (whichever is greater). The main bars are perpendicular to the treads and risers the distribution bars are perpendicular to the main bars and are above it.