This is to allow for expansion of the hot water-- otherwise the cylinder would blow up.
That depends on the starting temperature of the cold water and the starting temperature of the hot water.
The number of gallons of water a Cal Spa hot tub can hold varies. Each hot tub in this brand is a different size and therefore can hold different amounts of water.
350 gallons
560
because "one wrong turn and you're in hot water"
when your engine is hot it causes the water to boil and the water and the anti freeze will come out of the overflow pipe.
I take it you are talking about the large (header) tank in your loft which feeds your hot water cylinder. If so its the ball valve leaking and needs a washer replacing. hope this helps. Gaz
Your hot water heater may be leaking from the overflow pipe due to high water pressure, a faulty temperature and pressure relief valve, or a buildup of sediment in the tank causing overheating. It is important to address this issue promptly to prevent further damage and potential safety hazards.
water keeps running out of my overflow pipe outside. this has only happened in the last few days and could run twice. wy do you think this is happening what can i do to fix it or do i need a plumber thank you
Hot water pipe rust first as compared to the cold water pipe for the same chemical composition of the water.
A hot water cylinder tray is a protective barrier or catchment device placed underneath a hot water cylinder to prevent water damage in case of leaks or drips. It helps contain water and direct it away from the surrounding area, providing added protection for the property.
This type of question refers to the gravity type fed hot water heater and the correct level is just below the overflow pipe, however it is personal preference.
Check the overflow pipes and pans to be certain that they are not clogged.
Cold water pipe.
8m
8m
To clean a sink overflow effectively, start by pouring a mixture of baking soda and vinegar down the overflow hole. Let it sit for a few minutes, then flush it with hot water. Use a pipe brush or a toothbrush to scrub away any remaining debris. Repeat the process if necessary until the overflow is clean.