0
Eight turns of a screw advance it 4 inches. How many inches will ten turns advance it?
Wiki User
∙ 7y ago
8 turns-4 inches
2 turns-1 inch
10 turns-5 inches
I can explain;)
when we divide the eight turns by 4, we must divide 4 inches by 4 too. Then, when we multiply the 2 turns by 5, we must multiply the 1 inch by 5 too.
Hope this clarified your doubts><
w
FireryCobra
MOTOCAMP JR
Anonymous
don't tell me that you people are that bad in basic math: if 8x = 4 then what does 10x equal.
Anonymous
Trivial math: you're turning it 10/8=1.25 times as much, and 1.25*4=5 inches.
Anonymous
8 turns for 4 inches would mean each turn = half an inch. 10 turns would be 2 more half inches so the answer would be 5
Anonymous
4/8=1/2 1/2=.5 10/.5 = 5" Simple Math
Anonymous
4/8=1/2 1/2=.5 10/.5 = 5" simple math
Anonymous
6
Anonymous
10
Anonymous
5 inches
Anonymous
5 inches
Add your answer:
Earn +20 pts
If a screw moves one inch in 12 turns how many inches will it move in 30 turns?
2.5 inches
What do the numbers for a screw mean?
length of the screw, and number of turns per inch
How much is 10 Inches in a mile?
A mile is 5280 feet = 5280 x 12 inches = 63360 inches. Divide this by 10 to find the number of 10 inches which turns out to be 63360/10 = 6336
How do you calculate the number of turns in a threaded screw?
Divide the threaded length by the lead length. For single threaded screws the lead is the same as the pitch.
What is 112.38 rounded to the nerest tenth?
It is 112.4 rounded to the nearest tenth
If a screw moves one inch in 12 turns how many inches will it move in 30 turns?
2.5 inches
Is a screwdriver a type of screw?
NO, a screwdriver is what turns the screw.
What do the numbers for a screw mean?
length of the screw, and number of turns per inch
Need carb settings for loncin 50cc quad bike?
Screw both needles all the way in. Small one, screw out 2 1/2 turns. Needle with spring, screw out 3 turns.
How many turns out on the fuel screw on a 1992 Honda nighthawk 250?
two and half turns (so it is 5half turns)
How is the effort applied in the screw jack?
The effort is applied in the screw jack by turning the head of the screw. This then turns the jack a certain amount according to the pitch.
How do you set carburetor on 1985 XR80 Honda?
Stock setting is Idle screw - 2 1/2 - 3 turns out Air screw - 1 1/2 -1 3/4 turns out
What is the natural motion of a drill bit of a screw driver?
To rotate as it turns screws
What part of a screwdriver is axle?
The post between the handle and the tip that turns the screw.
What part of a screwdriver is the axle?
The post between the handle and the tip that turns the screw.
What is the initial pilot screw setting on a 1982 virago 920?
2 turns out.
What is the fuel mixing screw setting for brigs 3 hp?
Screw it in until it seats lightly and back it out 1 and 1/2 turns .
