Each computer will have an amperage rating. Using 80% rule for continuous load you should not exceed 16 Amps total. You'll have to add in your monitor power as well. Your start up current can be slightly higher due to bringing discs up to speed.
A typical desktop might draw from 2 to 3 amps. Depending on type a monitor may draw from 1 to 3 amps.
A typical laptop may draw 1.5 amps from charger.
No. If device draws 200 amps breaker will trip.
50 amp breaker.
It's the amps that are controlled by the breaker not the volts. You can have a 600 volt 15 amp breaker, you can have a 347 volt 15 amp breaker. The breaker will trip when you exceed 15 AMPS.
Depends on the size of the wire going to the A/C. If the wire is AWG #10 you cannot install a 40 amp breaker. If the wire is AWG #8 you can.
No tandem breakers are of the same value.
No. If device draws 200 amps breaker will trip.
50 amp breaker.
It's the amps that are controlled by the breaker not the volts. You can have a 600 volt 15 amp breaker, you can have a 347 volt 15 amp breaker. The breaker will trip when you exceed 15 AMPS.
A 32 amp fixture can not be fed from a 20 amp breaker as the breaker will trip every time.
Replace the 30 Amp Breaker with a 15 Amp breaker.
A 50 amp breaker is an overcurent device.
You have a double pole breaker for 240Volt supply. The maximum current is 15 amp.
NO!
Yes, a 30 amp breaker is a 30 amp breaker. It must however be able to fit the box it is installed in.
No more than 13 maximum on a 20 amp circuit.
Depends on the size of the wire going to the A/C. If the wire is AWG #10 you cannot install a 40 amp breaker. If the wire is AWG #8 you can.
No tandem breakers are of the same value.