Rule of thumb would be 8.
The breaker you use is determined by the size of the wire in the wall not by what is being connected to that circuit. If you have 14/2 wire then use a 15 amp breaker. If you have 12/2 wire then use a 20 amp breaker. The breaker protects the wiring not the item connected.
You have a double pole breaker for 240Volt supply. The maximum current is 15 amp.
No more than 13 maximum on a 20 amp circuit.
Depends on the wire size you are using. If the generator breaker is a 30 amp then install a 30 amp breaker.
AWG 12/2 requires the use of a 20 amp single pole breaker.
You can't.
no. the breaker is 40amps.fire hazard
No, you should not install a 30 amp circuit breaker to a machine which normally requires a 20 amp supply. The circuit breaker is protecting the wire to the machine. That wire is likely only rated for 20 amps, (# 12 awg). Therefore, a 30 amp breaker could allow too much current to go through the wiring to the machine and cause the wire to burn down. Replace the 3 phase 20 amp breaker with the same amperage breaker.
On a 15 amp household breaker there is no terminal on the in feed of the breaker. The breaker either plugs into the distribution panel's bus bar or it bolts to the distribution's bus bars. The feed conductor connects to the load side of the breaker at its terminal lug.
50 amp breaker.
The breaker you use is determined by the size of the wire in the wall not by what is being connected to that circuit. If you have 14/2 wire then use a 15 amp breaker. If you have 12/2 wire then use a 20 amp breaker. The breaker protects the wiring not the item connected.
The breaker you use is determined by the size of the wire in the wall not by what is being connected to that circuit. If you have 14/2 wire then use a 15 amp breaker. If you have 12/2 wire then use a 20 amp breaker. The breaker protects the wiring not the item connected.
It's the amps that are controlled by the breaker not the volts. You can have a 600 volt 15 amp breaker, you can have a 347 volt 15 amp breaker. The breaker will trip when you exceed 15 AMPS.
A 32 amp fixture can not be fed from a 20 amp breaker as the breaker will trip every time.
Replace the 30 Amp Breaker with a 15 Amp breaker.
A 50 amp breaker is an overcurent device.
You have a double pole breaker for 240Volt supply. The maximum current is 15 amp.