It is unusual to have multiple outlets on a 30 Amp service. If you do this you need outlets rated at 30 amps and 10 AWG wire.
8 ga
You can do a 30 amp twist lock receptacle 220v 3 wire (nema L6-30R) or a strait blade 30 amp 220v 3 wire receptacle (nema 6-30R) or a traditional 30 amp dryer plug. The nema # is a universal # that everyone uses to identify that plug. Ask for it. The most important part is the 30 amp male that your trying to plug in. Match it up with what you putting in the wall. Use #10 gauge wire for 30 amps
To answer this question the voltage of the pump must be stated.
You can't "change" the outlet to a 30 amp.The major limitation is the size of wire that feeds the outlet. A 15 amp circuit is typically run with 14 AWG wire. A 30 amp circuit must use 10 AWG wire.To add a 30 amp circuit you'll need to run a new wire, new outlet and connect it all to a new breaker.Always seek the services of a qualified electrician to make those kinds of changes. A mistake can lead to electrical fires and possibly death of someone in the home.
#10 wire is used on a 30 amp service.
Hi, I have the same question myself. I spoke to a electrician today he suggested I go with a new* 50 amp service in my camper do away with the old 30 Amp service all together off the new 50 amp service run 30 amp side of the breaker to my airconditioner or my stackable 220 washer/dryer combo and put couple other 15-20 amp breakers in my box for my lighting he suggested that way it also allows play for adding or modifying my breaker box as my needs change its always better to have more than not enough he quoted.... hope this helps a little
50 mm or 2 inch will handle the 3/0 wires for a 200 amp service.
It is unusual to have multiple outlets on a 30 Amp service. If you do this you need outlets rated at 30 amps and 10 AWG wire.
Assuming you mean 12 volts, then you cannot run any 78 Amp fans. Unless your fans run at 0.38 volts, there is no way to draw 78 amps from 30 watts.
10 gauge wire will only run up to 30 amps
10 AWG.
8 ga
No. A 120 volt 15 amp service will handle a maximum of 1,800 watts. Even a 20 amp service will only handle 2400 watts and that is at max load which you should never load on a 20 amp circuit. You will need a 30 amp 120 volt or 240 volt service for 2400 watts.
You can do a 30 amp twist lock receptacle 220v 3 wire (nema L6-30R) or a strait blade 30 amp 220v 3 wire receptacle (nema 6-30R) or a traditional 30 amp dryer plug. The nema # is a universal # that everyone uses to identify that plug. Ask for it. The most important part is the 30 amp male that your trying to plug in. Match it up with what you putting in the wall. Use #10 gauge wire for 30 amps
To answer this question the voltage of the pump must be stated.
Replace the 30 Amp Breaker with a 15 Amp breaker.