pressure?
altitude?
there's lots of possibilities.
The area can affect the speed of a fluid by changing the rate at which the fluid flows. In general, if the area through which the fluid flows is increased, the speed of the fluid will decrease. Similarly, if the area is decreased, the speed of the fluid will increase. This is because the volume of fluid flowing per unit time must remain constant, so if the area increases, the fluid spreads out and slows down, and if the area decreases, the fluid is forced to accelerate.
Yes, it must be.
You must be with K12 if you are it is The surface area of A is greater than the surface area of B.
Yes it is the source of your power and if it leaves you three times you will die painfully. After it exits you you must consume it to regain your power.
Capillaries are tiny blood vessels. They need to have a greater surface area to volume ratio because they need to diffuse oxygen quicker.
ISO-TONIC If a concentration of fluid is greater outside of the cell, then the cell will be in a hypotonic solution. Then it will expand and possibly explode. If a greater concentration of fluid is inside the cell, then the cell will be in a hypertonic solution. Then the fluid will diffuse out of the cell and it will become shriveled up and lose it's effectiveness. When the right concentration of fluid is the same as inside the cell as outside, then the solution is isotonic (where the cell wants to be).
they have a greater surface-to-volume ratio
If a pipe's diameter changes over its length, a fluid flows through narrower segments of the pipe faster than it flows through the wider segments. Since the volume of flow per second must be constant through the entire pipe, the fluid must flow faster as the cross-sectional area of the pipe narrows (think of the velocity of water squirted by a hose with and without a nozzle).Based on the law of continuity, you might think that blood should travel faster through capillaries than through arteries, because the diameter of capillaries is very small. However, it is the total cross-sectional area of the capillaries that determines flow rate. Each artery conveys blood to such and enormous number of capillaries that the total cross-sectional area is much greater in capillary beds than in any other part of the circulatory system.For this reason, the blood slows substantially as it enters the arterioles from arteries, and slows further in the capillary beds. As blood leaves the capillaries and enters the venules and veins, it speeds up again as a result of the reduction in total cross-sectional area.
It isn't always - for instance: static friction (standing still) is greater than moving friction. BUT, Air resistance (or water resistance for boats) increases with speed - quite rapidly. The reason for the increase is that you must move the fluid out of the way in less time as you speed up.
A sophisticated equipment must possess multipurpose utility along with greater accuracy, greater sensitivity, greater precision.
No, it must be the manufacturer recommended fluid.
yes. take an obtuse triangle that has a base of 8cm and a height of 3cm. then, take a right triangle that has a base of 3 cm and a height of 4 cm. do the math. the obtuse triangle will have a greater area. hope this helps.