Want this question answered?
okay here is the difrence a cuboid is a shape that is 3D and has eight faces a cylinder however is a 3D shape but it only has 2 faces the top and the bottom face
Draw a rectangle for the side of the cylinder and on top and bottom of this rectangle 2 circles for the base and the top of the cylinder The rectangle width would be the diameter of the circle large and the same height that the cylinder
a cylinder has two faces on the top and bottom.
The bottom of a graduated cylinder is flat, so it can sit on a table while you are doing your work.
A cylinder has two edges one at the top and one at the bottom.
Generally the nominal diameter of cylinder bore is kept little smaller at cylinder head than at the bottom. The engine head will be generally heat and it tends to expand for these high temperatures. To prevent the bore diameter at head to exceed diameter at bottom,piston engine bore is ground with a slight choke.
okay here is the difrence a cuboid is a shape that is 3D and has eight faces a cylinder however is a 3D shape but it only has 2 faces the top and the bottom face
You would just trim off the paper that sticks out the bottom or top.
Draw a rectangle for the side of the cylinder and on top and bottom of this rectangle 2 circles for the base and the top of the cylinder The rectangle width would be the diameter of the circle large and the same height that the cylinder
That depends entirely on what material it's made from ! The dimensions are irrelevant unless you tell us what it's made from !
VariablesD = Cylinder diameter [L].Dbot = Cone bottom diameter [L].Dtop = Cone top diameter [L].h = Cone height [L].L = Cylinder length [L].T = Top width of liquid in cylinder [L].y = Liquid depth in sphere or cylinder [L].z = Horizontal to vertical side slope of cone. zDbot.Ø = Angle representing how full the cylinder is [radians or degrees]. An empty cylinder has Ø=0o, a cylinder with Ø=180o is half full, and a cylinder with Ø=360o is completely full.
the top is the giver while the bottom is the receiver
The difference between the core and the lithosphere is the core is on the top of the lithosphere and the lithosphere is on the bottom of the core
the difference between them is that the bottom face is different one of them is a rectangle and one of them is a square
The sandy-bottom is all sand, and the live-bottom is plant life.
You measure from the bottom of the meniscus. The top of the meniscus can vary wildly depending on the diameter of the tube, or the air pressure, or room temperature.
the difference between them is that the bottom face is different one of them is a rectangle and one of them is a square