Limit of Linearity is the concentration at which the calibration curve departs from linearity by a specified amount. A deviation of approximately 5% is usually considered the upper limit. Common at higher concentrations.
the stitching.
In the context of Euclidean straight lines it would mean parallel lines. In the context of a curve and a line (or another curve) it would mean the line and the curve do not meet at any point, but not a lot more can be deduced about them.
A bell curve describes the graphed curve that normal distribution produces for a set of data. The curve slopes upward before returning downward after the point of the mean.
A bell curve reaches its highest point in the middle and is lower on the sides. It can represent standard deviations from the mean.
calibration curve helps you determine the value of a unknown substance
Why Calibration curve method is more reliable than single point method?Read more: Why_Calibration_curve_method_is_more_reliable_than_single_point_method
See this link.
i was suppose to get the anwer from yuo
The calibration curve for an orifice meter will depend on the size of the orifice, the size of the pipe and the pressure loss over the meter. Typical calibration curves have pressure (or head) loss on the vertical (y) axis and flow rate on the horizontal (x) axis.
With using a standard addition method the influence of matrix presented in sample is reduced.But standard addition corrects only for multiplicativeinterferences (changes in calibration curve slope), not additive interferences (changes in calibration intercept, such as spectral interferences). See http://terpconnect.umd.edu/~toh/models/Bracket.html
For a calibration curve method it is required that the composition (matrix) of standard and sample is nearly identical.when it is impossible to match the composition of the sample with the standard.we use standard addition method.
You need a calibration curve for D-glucose
Chromatography can help separate individual components of a complex mixtures AND quantify them with the use of a calibration curve.
Sorry, since it is unknown of what experiment or laboratory analysis you're talking about, this question is unanswerable. It also is not accurate enough: FeNCS is not a good formula, SCN is an anion: SCN- and the sentence:".... when the calibration curve was prepared(??) would this raise or lower the value of Keq" is difficult to interprete as such a curve is not adequately described.
Calibration Sensitivity(m): slope of acalibration curve at the consentration of interest y=mx+n m:slope(Calibration Sensitivity) x:concentration n:signal of blank Analytical Sensitivity: response to noise ratio A.S=m/S m:slope S:standard deviation of the measurement
curve means Bend