14 AWG.
For a 15 amp circuit, it is recommended to use 14-gauge wire.
For a dryer installation, it is recommended to use a wire gauge of 10 AWG (American Wire Gauge) for a 30-amp circuit or 8 AWG for a 40-amp circuit.
Use 8 gauge wire.
No, 10 gauge wire requires the use of a 30 amp breaker. A 20 amp breaker is only used on 12 gauge wire.
Normally it is a 20 amp using AWG 12/2 gauge wire. But it really depends on what size wire is on that circuit. If it is white AWG 14 gauge then use a 15 amp breaker. If it is yellow AWG 12 gauge then use a 20 amp breaker.
wire gauge is used to determine the size of the wire to be installed based on the amperage draw of whatever is being hooked up on the receiving end. ie 14 gauge is for a 15 amp circuit, 12 gauge is for a 20 amp circuit, 10 gauge 30 amp etc. to get specific amp draw ratings on a particular gauge of wire look at a current National Electric code book or ugly book.
No, it is not safe to parallel 10 gauge wire for a 60-amp circuit. You should use a wire size that is rated for the amperage of the circuit to ensure it can handle the load safely and prevent overheating. In this case, you should use a minimum of 6 gauge wire for a 60-amp circuit.
A 14 gauge wire is typically used on a 15 amp circuit breaker. It is not recommended to use a larger circuit breaker with a smaller wire size as this can create a fire hazard.
For an electric stove installation, it is recommended to use a wire gauge of 8 AWG (American Wire Gauge) for a 40-50 amp circuit or 6 AWG for a 50-60 amp circuit. This will ensure safe and efficient power supply to the stove.
12 gauge underground wire or if you think you will ever add any devices to this circuit use 10 gauge.
If you have 100 amp wire, you can use it for a 60 amp circuit, or for any circuit of 100 amps or less. But if you have a 60 amp circuit, 60 amp wire is thinner and cheaper than 100 amp wire.
To properly wire a 30 amp breaker for your electrical circuit, you should use the appropriate gauge wire (typically 10 gauge for a 30 amp circuit), connect the wire to the breaker terminal, and then run the wire to the outlet or device you are powering. Make sure to follow all local electrical codes and safety guidelines when performing this task.