Want this question answered?
4800
Try it see what happens... >:l Can you splice them? Yes. Should you splice them? No. It really all depends on what your over current protection is. If your #12 wire is on a 20 amp breaker, your #18 wire can melt and cause a fire without tripping the breaker. I do not know what is the amp rating of 18 gauge wire. -- Sparkfighter
The 240 volt receptacle has to have an amperage rating. It is this rating that governs the wire size and breaker size to feed the circuit. The new two pole breaker will be inserted in the 100 amp distribution if space is available and connected to the new wiring that terminates at the new receptacle.
No, 10 gauge wire requires the use of a 30 amp breaker. A 20 amp breaker is only used on 12 gauge wire.
16 gauge is rated at 13 amps, but I would use 14 gauge which is rated at 15 amps just to be safe.
That is 10 amp wire.
10
The ampacity or amp rating of all wire is rated by the size of the wire. NM (non-metallic sheathing) wire is no different. In household wiring 14 gauge wire must go on a 15 amp breaker/ 12 gauge goes on a 20 A and 10 gauge goes on a 30 Amp.
80 amps
Use 8 gauge wire.
The current (amp) capability is determined by the wire size in gauge, rather than the voltage rating stamped on the insulation. The most basic rating is 20 Amps for 12 gauge and 15 Amps for 14 gauge wire; however, it can get more complex than that for long runs of wire or for wires run through conduit with other wires. Hire an electrician if this sounds bewildering.
# 3 gauge
10 gauge will work fine.
4800
first off. it has to be UF type wire, and is usually 12 gauge or 10, depending what you are using it for.
Under normal household conditions it is 15 amps.
For a 220 volt 100 amp breaker, you would typically need a wire gauge of 2/0 AWG (American Wire Gauge) or larger. It is recommended to consult with a professional electrician to ensure the proper gauge is used for your specific installation.