the curve length L is equal to 100 * delta angle/2 but if you only know the deflection angle then use R = 5729.58/ Deflection angle (in degrees) and once you have you find a way around it lol
A zero deflection is the adjustment of a sight, parallel to the axis of the bore of the gun to which it is attached.
Because load and deflection are directly proportional to each other
As we mentioned earlier, a CRT can be used to graphically and visually plot an electronic signal,such as a sine wave. This is done by using a second set of deflection plates called VERTICAL-DEFLECTION PLATES
It is the amount if current it takes for unit deflection in the given galvanometer. k = I/theta Where k is the figure of merit, I is the current supplied and Theta equals the number of divisions of deflection.
the curve length L is equal to 100 * delta angle/2 but if you only know the deflection angle then use R = 5729.58/ Deflection angle (in degrees) and once you have you find a way around it lol
Angle A=opposite/adjacent shift tan Angle B=90-Angle A
The angle of deflection is the same as the angle of reflection relative to the Base Angle of the source. Resistive, Magnetic, Radiant and other Co and Anticohesive infuences, such as HiFi speaker reproduction, may need to be calculated.
I dont know :D
It is the deflection on the screen (meter) per volt of deflection
The angle is tan-1(M/E)*(D/R)2 where M is the mass of the earth, E is the mass of the mountain, R is the distance of the plumb bob from the centre of mass of the earth - near enough the earth's radius, D is the distance of the bob from the centre of mass of the mountain. Both M/E and D/R will be small so that the angle will also be small. In that case, the tangent of the angle will be close to the angle itself (measured in radians). So the angle of deflection is approximately (M/E)*(D/R)2 radians.
maximum deflection will accure
Deflection is a change of course, essentially. An example sentence would be: His deflection, eventually, brought him to meet his wife.
The Coriolis effect is the clockwise deflection of air in the north hemisphere and the counterclockwise deflection in the Southern Hemisphere.
The Coriolis effect is the clockwise deflection of air in the north hemisphere and the counterclockwise deflection in the Southern Hemisphere.
Electromagnetic deflection is used because it can create greater deflection angles of the electron beam compared to electrostatic deflection.
The deflection v is the displacement in the y direction of any point on the axis of the beam. Because the y axis is positive + upward, the deflection is also positive when upward (when downward, of course it is negative).Now the slope of the deflection, v', is the first derivative dv/dx of the expression for the deflection v. In geometric terms, the slope is the increment dv in the deflection (as we go from point m1 to point m2) divided by the increment dx in the distance along the xaxis.Since dv and dx are infinitesimally small, the slope dv/dx is equal to the tangent of the angle of rotation θ. Thus, dv/dx=tanθ and θ=arctan dv/dx.I hope i was helpful :P :)