the curve length L is equal to 100 * delta angle/2 but if you only know the deflection angle then use R = 5729.58/ Deflection angle (in degrees) and once you have you find a way around it lol
A zero deflection is the adjustment of a sight, parallel to the axis of the bore of the gun to which it is attached.
Because load and deflection are directly proportional to each other
As we mentioned earlier, a CRT can be used to graphically and visually plot an electronic signal,such as a sine wave. This is done by using a second set of deflection plates called VERTICAL-DEFLECTION PLATES
It is the amount if current it takes for unit deflection in the given galvanometer. k = I/theta Where k is the figure of merit, I is the current supplied and Theta equals the number of divisions of deflection.
the curve length L is equal to 100 * delta angle/2 but if you only know the deflection angle then use R = 5729.58/ Deflection angle (in degrees) and once you have you find a way around it lol
Angle A=opposite/adjacent shift tan Angle B=90-Angle A
The angle of deflection is the same as the angle of reflection relative to the Base Angle of the source. Resistive, Magnetic, Radiant and other Co and Anticohesive infuences, such as HiFi speaker reproduction, may need to be calculated.
The angle of deflection of a charged particle in a magnetic or electric field is not affected by its mass. The angle of deflection is determined by the charge and velocity of the particle, as well as the strength of the field.
I dont know :D
Steady deflection in a ballistic galvanometer occurs because the coil has momentum when current is flowing through it. As the current is interrupted by a switch, the coil continues to rotate due to its inertia, resulting in a steady deflection. The deflection angle is directly proportional to the total charge that passed through the coil during the pulse of current.
Slope is the change in elevation along a horizontal axis, while deflection is the angle at which a beam or structure bends under a load. Slope is measured in length/length or radians, while deflection is measured in degrees or radians. In other words, slope describes the inclination of a line or surface, whereas deflection describes the bending or curvature of a beam or structure.
It is the deflection on the screen (meter) per volt of deflection
The angle is tan-1(M/E)*(D/R)2 where M is the mass of the earth, E is the mass of the mountain, R is the distance of the plumb bob from the centre of mass of the earth - near enough the earth's radius, D is the distance of the bob from the centre of mass of the mountain. Both M/E and D/R will be small so that the angle will also be small. In that case, the tangent of the angle will be close to the angle itself (measured in radians). So the angle of deflection is approximately (M/E)*(D/R)2 radians.
To compare the magnetic moments of two magnets using a deflection magnetometer, you would place one magnet at a known distance from the magnetometer and measure the angle of deflection caused by its magnetic field. Then, you would repeat the process with the second magnet at the same distance and compare the angles of deflection. The magnetic moment of the magnets can be compared by the ratio of the sine of the angles to the distance and the Earth's magnetic field strength.
maximum deflection will accure
The Coriolis effect is the clockwise deflection of air in the north hemisphere and the counterclockwise deflection in the Southern Hemisphere.