by using a caliperhttp://www.technologystudent.com/equip1/vernier3.htm
hello stupid person! You don't know what outer diameter is...!
Radius is from the center of a circle to the outer edge. Diameter is from the outer edge to the opposite outer edge, i.e., through the center. The diameter has twice the length of the radius.
he diameter of the bolt.
10 percent of 832 = 83.2%10% of 832= 10% *832= 10%/100% *832= 832/10= 83.2
by using a caliperhttp://www.technologystudent.com/equip1/vernier3.htm
On a five bolt pattern measure from outer edge of one bolt then across to the middle of another skipping one bolt hole( not quite the diameter). On six or four bolt patterns measure across from bolt center to bolt center as you would the diameter if it were a circle.
hello stupid person! You don't know what outer diameter is...!
This would be concidered the largest diameter,dimension of a bolt.
the combined diameter of all the outer planets is 363,546 kilometers, or 84% the diameter of the sun.
Radius is from the center of a circle to the outer edge. Diameter is from the outer edge to the opposite outer edge, i.e., through the center. The diameter has twice the length of the radius.
Remembering that there is an inner core inside the outer core - the radius of the outer core/mantle boundary is about 3,400 km. (the diameter is twice the radius).
Consider going across the width of the pipe: Outer diameter = Thickness + Inner diameter + Thickness so 2*Thickness = Outer diameter - Inner diameter = 2.5 - 2.1 = 0.4 inches and therefore, Thickness = 0.2 inches.
he diameter of the bolt.
The stress on a bolt under longitudinal force is the total force on the bolt divided by the stress area. The stress area is a little bigger than the minor diameter area, calculated from the average of the minor diameter and pitch diameter. The total force on the bolt is its torque preload plus the (bolt stiffness/(bolt +member stiffness) x (externally applied load )
Disconnect the battery. Remove the outer bolt entirely. Loosen the inner bolt. Slide the starter shim in over the inner bolt and line it up with the outer bolt hole to get the outer bolt back in. Tighten the bolts. Start with a thin shim first and work your way bigger if needed.
Jupider