0
A 12 gauge wire can support a load of approximately 2200 watts.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
What size wire should be used from main panel to 50 watt subpanel?
#6 wire is needed. If placing the subpanel in a garage at a good distance, it is recommended to also install a seperate ground rod .
What size wire do you need for a 100amp braker?
Service entrance wire should be AWG #3 copper.
What wire size for 400 amp service neutral size?
You need to look at the regulations that apply in your country. If in doubt, use a neutral wire of the same size as the live wire or wires.
What size of wire cu do you need for 50 amps?
6 AWG.
What size wire do you need for 15 amps?
AWG 10.
What size wire do you need for a 30 watt mixer?
Need to know the voltage of the mixer.
What size gauge power wire do you need for a 4000 watt amp?
2 or 4
What size wire needed to power 100 watt bulb?
In a floor lamp or table lamp a #16 wire is what you need.
What size gauge power wire do you need for a 1200 watt amp?
You should use a 4 guage wire. There is a handy chart located at http://www.the12volt.com/info/recwirsz.asp which lists the proper wire size for differing wattages.
How do you wire a high watt light to a battery?
Need more information. Wattage of bulb, voltage of bulb, voltage of battery and wire size of the circuit.
What size wire do you need to run 4 1500 watt 240v lights spaced out over 200ft span?
10 gauge will suffice.
When calculating wire size do you add both 4500 watt elements together?
Yes, if the elements are operating simultaneously, you would need to have sufficient ampacity (wire size) to supply both. If they only alternate, one at a time, you could use a smaller wire.
What cable wire size for 1000 watts aircondition?
The only way to determine the cable wire size needed for a 1000 watt air conditioner is to find the load size. To get the load size you will need to use the formula Amps = Watts or Volts. With that being said, you will need a number 14 copper wire.
What gauge wire do you need for 1800 watt amp and 2 550 watt subs?
4 gauge
What size wire do i need to feed a single phase V primary and a V secondary fed from a 150 amp circuit breaker?
Information is incomplete. You need to know the load in Watt or Kilowatt and the voltage on the secondary side to determine the load current, on which the size of the wire is designed.
What wire size needed for 120 volt 3000 watt load?
AWG # 10 wire on 30 amp circuit.
What size gauge wire for 4000w amp?
on a 4000 watt amp the best gauge wire woul be between 2 and 0
