Want this question answered?
This question cannot be answered because you did not specify the current.
Its dependent what will by rated power of the device (current).
Each baseboard heater will draw a little over 4 amps at 120 volts or 2 Amps at 240 volts. The total number of baseboards on a circuit will draw the sum of these amps. Keep the load under 80% of the amperage rating of the breaker.
The V stands for volts and A is amps. If for example you have a 12kVA device and are running off a voltage of 120 volts then Amps = 12000/120 = 100. You then use the calculated amps in a wire size table to get the correct size.
For single phase 30 amps at 120 volts you would need a #8 copper wire with an insulation rating of 90 degrees C.
#8 copper
10 AWG in copper.
Four size D torch cells are needed for a 6-volt torch. Each size D torch cell typically provides 1.5 volts, so combining four of them will give a total voltage of 6 volts.
calculate in meters wood that will be needed for roof of a building with size 14.125m x 3.630.
one big one
This depends on the size of the generator itself. The smaller the generator, the more RPM's will be needed to generate 200 volts in an A/C system.
This question cannot be answered because you did not specify the current.
Depending on size of Fridge. But AVERAGE is 12 volts for fridge, circuit necessity 15 amps 15 amps X 120 Volts=1800 watts minimum...I'm LEARNING myself
14 AWG is fine for this application.
5 meters
The answer depends on the area, not the length. It also depends on the size of the tiles!
More information is needed in order to answer this question. The size of the pond, preferably in square meters.