This question cannot be answered because you did not specify the current.
AF refers to the ampere rating of the breaker frame and AT refers to the breaker trip rating in amps. These are not breakers that you would find in your home but industrial molded case breakers. The current trips can be changed out to different values all within the same frame size.
Its dependent what will by rated power of the device (current).
Each baseboard heater will draw a little over 4 amps at 120 volts or 2 Amps at 240 volts. The total number of baseboards on a circuit will draw the sum of these amps. Keep the load under 80% of the amperage rating of the breaker.
The V stands for volts and A is amps. If for example you have a 12kVA device and are running off a voltage of 120 volts then Amps = 12000/120 = 100. You then use the calculated amps in a wire size table to get the correct size.
#8 copper
Four size D torch cells are needed for a 6-volt torch. Each size D torch cell typically provides 1.5 volts, so combining four of them will give a total voltage of 6 volts.
calculate in meters wood that will be needed for roof of a building with size 14.125m x 3.630.
one big one
This question cannot be answered because you did not specify the current.
Depending on size of Fridge. But AVERAGE is 12 volts for fridge, circuit necessity 15 amps 15 amps X 120 Volts=1800 watts minimum...I'm LEARNING myself
The answer depends on the area, not the length. It also depends on the size of the tiles!
5 meters
More information is needed in order to answer this question. The size of the pond, preferably in square meters.
You don't. The cook top was designed to operate on 208 volts. This is the voltage needed to get the elements up to their rated wattage to do the cooking. Higher wattage appliances do not operate on the lower voltage because of the size of the wire that is needed to feed the appliance.
To answer this question the voltage of the genset is needed.
Depends on size.