Wire is sized by the amperage applied to the wire. To answer this question a voltage needs to be stated. I = W/E. Amps = Watts/Volts.
A #14 copper conductor is rated at 15 amps.
AWG # 10 wire on 30 amp circuit.
Look on the heater and see what amps it is pulling. That will determine the wire size and breaker size. It must be on a dedicated circuit. 15 amps = AWG # 14 wire with 15 amp breaker 20 amps = AWG # 12 wire with 20 amp breaker 30 amps = AWG # 10 wire with 30 amp breaker 40 amps = AWG # 8 wire with 40 amp breaker
I have a 760 watt amp powering 2 10" subs and it works fine. my brother has a 1000 watt amp powering 2 12" subs and he got a capacitor. So it really depends on what amp your looking at. if the 760w you wont need one, if the 1000w i would be safe and buy a capacitor. for the 1000w amp you would only need a 1 or 2 farad capacitor.
The wire size is dependent upon the wattage size of your water heater. The higher the wattage the larger the wire size. A standard 3000 watt heater will use a two pole 20 amp breaker connected to 2C #12 wire.
40 amp
on a 4000 watt amp the best gauge wire woul be between 2 and 0
2 or 4
You should use a 4 guage wire. There is a handy chart located at http://www.the12volt.com/info/recwirsz.asp which lists the proper wire size for differing wattages.
AWG # 10 wire on 30 amp circuit.
A 12 gauge wire can support a load of approximately 2200 watts.
Yes, but the amp is too powerful and if turned up to full volume will blow the speakers.
sure. Will it be loud? No. Its just not enough power to drive that sub.
Look on the heater and see what amps it is pulling. That will determine the wire size and breaker size. It must be on a dedicated circuit. 15 amps = AWG # 14 wire with 15 amp breaker 20 amps = AWG # 12 wire with 20 amp breaker 30 amps = AWG # 10 wire with 30 amp breaker 40 amps = AWG # 8 wire with 40 amp breaker
4 gauge
Look i have a 5500 watt power acustic amp and its saids not to use nothing under 0 gauge. So use that thicker wirer mean better performance. Try it!!
18 gauge
I have a 760 watt amp powering 2 10" subs and it works fine. my brother has a 1000 watt amp powering 2 12" subs and he got a capacitor. So it really depends on what amp your looking at. if the 760w you wont need one, if the 1000w i would be safe and buy a capacitor. for the 1000w amp you would only need a 1 or 2 farad capacitor.