if it is a 240volt motor it does not matter,
The ground terminal on an H3 bulb is typically the metal tab or contact on the base of the bulb. It is usually connected to the vehicle's grounding system to complete the electrical circuit.
A L14-20P is a 3 pole 4wire 125/250 volt grounding plug. The four wire (white, red, black and green) cable connection will be, white wire to the W terminal, red to the X terminal, black to the Y terminal and green to the G terminal. The X and Y terminals wires (red and black) can be interchanged so that there is no cross over of the conductors as they protrude from the cable jacket.
In the hot tub junction control box there should be three terminals. The terminal block might say line voltage. This is where the incoming "hot" wires connect. The red and black wires will probably be for the 240 volt pump motor and one of the two "hot" wires and the white wire will be used for the controls that control the pump.
Black wire to gold screw terminal, white wire to silver screw terminal, ground wire to ground terminal. I am sorry, I can't even begin to answer this question. I don't what you are trying to do and I am positive you don't either. Call a pro, please...pkazsr
The switch will be wired in series with the motor. It is connected between the supply voltage and the motor's junction box. The switch will break the black wire while the white wire is just wire nutted together and is carried directly through to the motor.
Bill wears a Rolex Dayton (White Face)
Yes-connect the black wire to the brass terminal and the white wire to the silver terminal.
you can get a Stacy white coat from wet seal in the dayton mall or order it offline from a fashion company
White Motor Company was created in 1900.
white
You don't say what you are connecting to the battery. If you have a black and white wire the best guess would be white to negative terminal and black to positive terminal. If you were connecting a 6V light bulb it really doesn't matter.
Wall receptacles are wired in parallel. black to black, white to white, ground to ground.
It means thats you have terminal cancer
White
The ground terminal on an H3 bulb is typically the metal tab or contact on the base of the bulb. It is usually connected to the vehicle's grounding system to complete the electrical circuit.
the motor should have two leads, usually a black and a white. connect the white to the fusebox and the black to a ground.
A L14-20P is a 3 pole 4wire 125/250 volt grounding plug. The four wire (white, red, black and green) cable connection will be, white wire to the W terminal, red to the X terminal, black to the Y terminal and green to the G terminal. The X and Y terminals wires (red and black) can be interchanged so that there is no cross over of the conductors as they protrude from the cable jacket.