is easy to create and easy to troubleshoot
A star topology.A star topology.A star topology.A star topology.
Star topology is one of the oldest topology
It is a Client/Server system. The most common topology for this is a Star topology.
Star Topology is the most common type of network topology that is used in homes and offices. In the Star Topology there is a central connection point called the hub which is a computer hub or sometimes just a switch. In a Star Network the best advantage is when there is a failure in cable then only one computer might get affected and not the entire network.
A star topology is a method of connecting several computers to one another in a network. The cables used in a star topology are twisted pair cables or coaxial cables. Coaxial cables would be the cheapest solution.
Network Topology refers to the way that cables and other pieces of hardware connect to one another. There are four common "base" types of topologies: bus, ring, star, and mesh. There are other types as well, but these are referred to as "hybrid topologies." The most commonly used network topology is a hybrid topology called the Star Bus Topology.
Star topology:- In this topology all PC are connected with the central device. Central may be HUB and SWITCH. Star widely use in all over word. Ring topology:- In this ring topology all PC are connected in the frame of ring are close Ring topology use MSAU each PC has a two never road one is called up Stream and called down stream. It used token passing Matterhorn which implement the token ring network. " Is the best of star topology".
Token ring uses star topology . The data token is being passed from one computer to other allowing all the computer to have network access and avoids data collision.
There is actually more than three topologies for networking. Network topologies are categorized into the following basic types: * bus * ring * star * tree * mesh More complex networks can be built as hybrids of two or more of the above basic topologies.
in bus topology computers are connected with each other by a wire in a approximately strait manner..and if one computer stops working the whole network will stop. while in star topology every computer is connected with the host computer & much wire is require..and if any client computer tops working it will not effect the whole network.----ravi singh chauhan...7275974787
One of the most popular topologies for Ethernet LANs is the star and extended star topology. It is easy to setup, it's relatively cheap, and it creates more redundancy than the Bus Topology. The Star Topology works by connecting each node to a central device. This central connection allows us to have a fully functioning network even when other devices fail. The only real threat to this topology is that if the central device goes down, so does the entire network. The Extended Star Topology is a bit more advanced. Instead of connecting all devices to a central unit, we have sub-central devices added to the mix. This allows more functionality for organization and subnetting- yet also creates more points of failure. In many cases it is impractical to use a Star Topology since networks can span an entire building. In this case, the Extended Star Topology is all but necessary to prevent degraded signals. Whereas the Star Topology is better suited for small networks, the Extended Star Topology is generally better for the larger ones.
A star network uses a central server to route data between clients. The central server (or the switching hub) switches data around the network. Data flow between the server and the nodes will therefore be relatively low. A typical star network are mainframe computers. Star topology, also known as star network, is a computer network topology. It is a common network setup where the computers and other devices on the network are connected to a central or master computer, also known as the hub.