Yes, it is.
The weight will depend on how much of the substance there is.
2/3 of 70% and 1/3 of 10%
70 percent of 118 is 82.6
875 is 70 percent of 1250.
49/0.7 = 70 Therefore, the number that 49 is 70 percent of, is 70.
No, 70% isopropyl rubbing alcohol is a homogeneous mixture because it is a uniform solution of isopropyl alcohol with water. It has the same composition throughout and its components are evenly distributed.
Yes, rubbing alcohol (isopropyl alcohol) is a homogeneous mixture because it consists of a single phase with uniform composition throughout, typically containing 70% isopropyl alcohol and 30% water.
The weight will depend on how much of the substance there is.
A 70 percent isopropyl alcohol spray is commonly used for disinfecting surfaces, cleaning electronics, and sanitizing hands. It is recommended for killing germs and bacteria effectively.
Rubbing alcohol is a solution. It is a homogeneous mixture composed of 70% isopropyl alcohol and 30% water.
It is difficult and expensive to refine anything to 100% purity. Best to use 70% as it is just as effective and cost a whole lot less.
To make rubbing alcohol from isopropyl alcohol, you can mix it with water in a specific ratio. Typically, rubbing alcohol is made by combining 70 isopropyl alcohol with 30 water. This mixture creates a solution that is effective for disinfecting surfaces and skin.
Yes, 70 isopropyl alcohol is effective at killing germs.
Yes, 70 isopropyl alcohol can stain clothes if it is not promptly washed off.
Isopropyl alcohol has a rather strong alcohol smell. If you were to smell regular alcohol and smell 70% Isopropyl alcohol you would have the same smell. However, there is no general way to explain it other than a strong bitter and sometimes sweet smell. It depends on solely your olfactory membranes. Smell's are after all different to everyone.
The density of 70% isopropyl alcohol is approximately 0.87 grams per milliliter at room temperature.
The minimum recommended concentration of Isopropyl Alcohol to prevent contamination of an IV site is typically 70%. Below this concentration, it may not effectively kill bacteria and other microorganisms. Therefore, it is important to use a solution that contains at least 70% Isopropyl Alcohol to ensure proper disinfection.