A 220 volt line may put out 250 volts because this specification features voltage that varies between 220 and 250 volts. In other countries, the electricity varies in voltage between 110-120 volts.
you get a transformer...
To calculate the amperage in the secondary side of a transformer, you can use the formula: Amps = kVA / (Volts x Sqrt(3)). For a 250 kVA transformer with a 220-volt secondary, the amperage will be approximately 660.4 Amps.
220-250 Volt, as is the main part of the Europan Community.
12 Volts.
NO
The voltage in North America can be as low as 110 and as high as 125 volts. The average is about 115 to 117 volts. <><><>><> House voltage in the US is generally 120v line to neutral and 240v line to line. It is referred to as a "120/240v single phase service." Actual voltage can be as low as 110/220 or as high as 125/250.
Almost every home in north America will have a 240 volt supply (250 volts is the same).
The 2000 Honda Rebel 250 typically comes with a 12-volt electrical system.
Different voltage ranges in single-phase AC systems exist due to variations in electrical standards and utility practices across different regions and countries. The nominal voltage level (e.g., 220V, 230V) is typically chosen based on historical standards, equipment compatibility, and the balance between efficiency and safety. It's important for electrical devices to operate within their specified voltage range to ensure proper functionality and safety.
A 250 volt outlet with 30 amps can handle up to 7500 watts (250V x 30A = 7500W) of power. This calculation is based on the formula Watts = Volts x Amps.
depends on what the line is feeding. 220, 225, 230, 240, even 250 are all in the same catagory. power companies have increased their output voltages through the years. i would say 220 is minimum. if your connected load is a motor, they are more voltage sensitive, and should be run on 230 or 240. it makes the motor more effecient
For a 10 amp, 250 volt circuit, you should install a circuit breaker rated for at least 10 amps and 250 volts. A common option would be a single-pole, 10 amp circuit breaker designed for 240-250 volt applications. Be sure to check the specifications and compatibility with your specific electrical panel.