There is no single conductor that will handle 1500 amps. For ease of handling, the conductors should be installed in parallel, triple or quad runs. For a parallel run, 2 - 2000 MCM with an insulation factor of 90 degrees C will give you a total ampacity of 1550 amps. For a triple run, 3 - 750 MCM with an insulation factor of 90 degrees C will give you a total ampacity of 1500 amps. For a quad run, 4 - 500 with an insulation factor of 90 degrees C will give you a total ampacity of 1580 amps.
Conductors by code are only allowed to be loaded up to 80 percent. In this case an over size wire set will be higher that what the wire is rated for in the code book. A 600 MCM copper conductor with an insulation factor of 90 degrees C is rated at 455 amps. Paralleled together will give an ampacity of 910 amps. After the derate the maximum amperage allowed is 728 amps. So to get the full 900 amp the wire size has to be increased to a 1000 MCM copper conductor with an insulation factor of 90 degrees C which is rated at 585 amps. Paralleled this give you an ampacity of 1170 amps. After the derate the maximum amperage allowed is 1170 x 80% = 936 amps
A 10 mm squared conductor is equal to a #8 AWG. A #8 copper conductor with an insulation factor of 75 or 90 degrees C are both rated at 45 amps.
There is no wire insulation on this earth that can stand a temperature of 658 degrees C (1268 degrees F.).
It will taken 8 amps <<>> The conversion of 2.5 sq mm wire to AWG is equal to a #12 wire. The ampacity of a #12 copper wire with an insulation factor of 90 degrees C is 20 amps.
freezer temperature should be 8ca refrigerator for safety of food should be operated at 8 degrees or below to prevent contamination
The normal engine operating temperature, for a 3306 Caterpillar diesel engine, is 180 degrees. The engine should not be operated at temperatures above 200 degrees.
Using a Mercedes 190D-2.2 as an example; Normal operating temperature is around 200 degrees Fahrenheit. Keep in mind that the clutch operated radiator cooling fan is designed to shut off when the coolant temperature reaches 212 degrees Fahrenheit or 100 degrees Celsius and below. SPKB..
- 23 degrees
That can vary per vehicle, it could be around 227 degrees However, remember that water boils at 212 degrees. The boiling point of automotive coolant varies slightly from that, but the system is pressurized, so boiling is "normally" not a problem. Most modern, fuel-injected automobiles have a normal operating temperature of 190 to 195 degrees. Older cars operated at about 180 degrees.
The change in temperature is 49 degrees, calculated by subtracting the final temperature (-4 degrees) from the initial temperature (45 degrees).
5 degrees fahrenheit
If the temperature decreases by 30 degrees Celsius from 20 degrees Celsius, the new temperature will be -10 degrees Celsius.
If the temperature was 90 degrees below zero and dropped 24 degrees, the new temperature would be 114 degrees below zero.
The Celsius temperature of 32 degrees Fahrenheit would be 0 degrees.
A Celsius temperature of 100 degrees is equivalent to a Fahrenheit temperature of 212 degrees.
The temperature of 85 degrees Fahrenheit is 25 degrees cooler than a temperature of 110 degrees Fahrenheit.