No, the conduit has to be supported individually from a supportive structure. The spacing of the strapping is related to the size of the conduit.
For new 200 amp services the conduit size should be 3 inch PVC.
A trade size hole for a 2-1/2" EMT conduit connector, the hole needs to be 2-7/8" in diameter. A 3" rigid conduit can also use this size hole without the lock nuts falling into the hole.
Back set for all conduit sizes is not the same. The greater the diameter of the conduit the length of back set increases. Without the diameter size of the conduit, an answer can not be given.
Conduit bodies are used to provide pulling access in a run of conduit, to conserve space where a full size bend radius would be impractical, to allow more bends to be made in a section of conduit or to split a conduit path into multiple directions.
No, the conduit has to be supported individually from a supportive structure. The spacing of the strapping is related to the size of the conduit.
4 inch rigid conduit
Actual hole size for 1 inch conduit is 1.362"
The size of conduit is based on the size of the wires in it. The size of the wires depends on the load connected in the house. Without these other two values an answer can not be given.
120mm
For new 200 amp services the conduit size should be 3 inch PVC.
A trade size hole for a 2-1/2" EMT conduit connector, the hole needs to be 2-7/8" in diameter. A 3" rigid conduit can also use this size hole without the lock nuts falling into the hole.
Back set for all conduit sizes is not the same. The greater the diameter of the conduit the length of back set increases. Without the diameter size of the conduit, an answer can not be given.
ma - male adapter, fa - female adapter, coup - coupling, conn - connector, cap - end cap, reducer - bushings that reduce the size of a conduit to allow connection to a smaller size conduit, expansion joints - to allow the expansion and contraction in the conduit system.
Conduit bodies are used to provide pulling access in a run of conduit, to conserve space where a full size bend radius would be impractical, to allow more bends to be made in a section of conduit or to split a conduit path into multiple directions.
You can pull 10 #3 gauge wires in a 2 1/2" conduit.
depends on size....